Installing the Display on the Wall Attachment Panel
➢Refer to the correct installation guide according to your wall bracket.
Installation Notes
◆Contact a technician for installing the wall bracket.
◆Samsung Electronics is not responsible for any damages to the product or harm to customers when the installation is done by the customer.
◆This product is for installing on cement walls. The product may not stay in place when installed on plaster or wood.
Components
◆Only use the components and accessories shipped with the product.
| Wall Bracket | Hinge |
| Accessories | ||
|
|
|
|
| Plastic Hanger: 4 | Screw : 11 |
| 1 | Left: 1 | Right: 1 |
| Screw : 4 | Anchor : 11 |
|
|
|
| |||
Wall Bracket Assembly |
|
|
|
| ||
1 | Insert and tighten the Captive Screw in | 2 | Before drilling into the wall, check if the length | |||
| the direction of the arrow. |
|
| between the two locking holes at the back of | ||
| When done, mount the wall bracket on |
| the product is correct. |
| ||
| the wall. |
|
|
| If the length is too short or long, loosen all or | |
| Captive Screw |
|
|
| some of the 4 screws on the wall bracket to | |
|
|
|
| adjust the length. |
| |
| Length between the |
| two locking holes |
Wall Bracket |
|
Hinge (Left) |
|
There are two hinges |
|
(left and right). Use the |
|
correct one. | Hinge (Right) |
|
3 Check the installation diagram and mark the drill points on the wall. Use the 5.0 mm bit to drill holes deeper than 35 mm.
Fix each anchor in the corresponding hole. Match each of the brackets and hinge holes to the corresponding anchor holes and insert and tighten the 11 screws 
.
Continued...
English - 10