Samsung SP2553XWX/EN, SP2553WWX/EN, SP2253XWX/EN Connecting an AV device with Component output

2-14 Connecting an AV device with Component output

Make sure that the AV device and your projector are turned off.

1.Connect the [PC IN] terminal on the back of the projector to the Component terminal on your AV device using a D-Sub to Component cable (Not supplied). This cable has a D-Sub connector on one end and three RCA jacks on the other.

- For supported input signal formats, resolutions, and frequencies, see AV Timing (D-Sub) in Section 2-8, "Supported Display Modes".

2.Connect the [AUDIO IN (L-AUDIO-R)] terminal on the back of the projector and the Audio out terminal on your AV device using an audio cable (Not supplied).

Installation and Connection 2-14