Samsung HW-H7501/XN, HW-H7500/EN, HW-H7501/EN manual Connections, Connecting the Wireless Subwoofer

CONNECTIONS

CONNECTIONS

CONNECTING THE WIRELESS SUBWOOFER

The Subwoofer's linking ID is preset at the factory and the main unit and subwoofer should link (connect wirelessly) automatically when the main unit and subwoofer are turned on. If the Link indicator ( ) does not light when the main unit and subwoofer are turned on, please set the ID by following the procedure below.

ENG

1.Plug the power cords of the main unit and subwoofer into an AC wall outlet.

2.Press the ID SET button on the back of the subwoofer with a small, pointed object for 5 seconds.

•The STANDBY indicator is turned off and the LINK indicator (Blue LED) blinks quickly.

3.While the main unit is powered off (in STANDBY mode), press and hold the (Mute) on the remote control for 5 seconds.

4.The ID SET message appears on the Soundbar's display.

5.To finalise the link, turn the main unit’s power on while the subwoofer’s Blue LED blinks.

•The main unit and the subwoofer should now be linked (connected).

•The Link indicator (Blue LED) on the subwoofer should be on.

•If the Link indicator is not solid blue, the linking process has failed. Turn off the main unit and start again from Step 2.

•You can enjoy better sound from the wireless subwoofer by selecting a Sound Effect.

(See page 10)

●● Before moving or installing the product, be sure to turn off the power and disconnect the power cord.

●● If the main unit is powered off, the wireless subwoofer will be in standby mode and the STANDBY LED on the upper side will come on after the Link indicator (Blue LED) blinks for 30 seconds.

●● If you use a device that uses the same frequency (2.4GHz) as the Soundbar near the Soundbar, interference may cause some sound interruption.

●● The transmission distance of the wireless signal between the main unit and subwoofer is about 10 m, but may vary depending on your operating environment. If a steel-concrete or metallic wall is between the main unit and the wireless subwoofer, the system may not operate at all, because the wireless signal cannot penetrate metal.

●● If the main unit doesn't make a wireless connection, follow steps 1-5 in the left hand column to re-set the connection between the main unit and wireless subwoofer.

●● The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from water and moisture.

●● For optimal listening performance, make

sure that the area around the wireless subwoofer location is clear of any obstructions.