Samsung MAXL82QH/XFO, MAXL82RH/ELS, MAXL82RH/XEF manual Connecting your System to the Power Supply

Where to Install Your

Mini-Compact System

To take full advantage of your new mini-compact system, follow these installation instructions before connecting the unit.

Install the system on a flat, stable surface.

Never place this unit on carpeting.

Never place this unit in an outdoor area.

Maintain an open space of approximately 6 inches (15 cm) on the sides and rear of the system, for ventilation purposes.

Make sure that you have enough room to open the compact disc compartment easily.

Place the loudspeakers at a reasonable distance on either side of the system to ensure good stereo sound.

Direct the loudspeakers towards the listening area.

For optimum performance, make sure that both speakers are placed at an equal distance above the floor.

			Disc 1	Disc 2	Disc 3	Disc Change		Open/Close
								Power Surround
On/
Standby	Timer/
	Clock							Volume
	PTY
R	RDS
	Display
AUX	Demo	Band
		TUNER		CD			TAPE
								Sound
								Mode
							Enter
Mute	Mono/ST	Program		Reverse
				Mode
	Preset	CD Repeat		Deck 1/2	Counter
Phones	Memory				Reset
	REC/Pause	Shuffle	CD	Dubbing
			Synchro
				Normal	High	D
							Preset/Manual
						own		Up

Push Eject Push Eject

Connecting your System to the Power Supply

The main lead must be plugged into an appropriate socket.

Before plugging your system into a main socket, you must check the voltage.

1 Plug the main lead (marked AC Cord on the rear of the system) into an appropriate socket.

2 Press the On/Standby button to switch your mini-compact system on.
DIGITAL
OUT
(OPTICAL)
R	L
AUX IN

Inserting Remote Control Batteries

GB

Insert or replace remote control batteries when you:

Purchase the mini-compact system

Find that the remote control is no longer operating correctly

When replacing the batteries, use a new set of batteries and never mix alkaline and manganese batteries.

1	Place your thumb on the position marked	on the battery
	compartment cover (rear of the remote control) and push the cover in
	the direction of the arrow.
2	Insert two AAA, LR03 or equivalent batteries, taking care to respect
	the polarities:
	+ on the battery against + in the battery compartment
	– on the battery against – in the battery compartment
3	Replace the cover by sliding it back until it clicks into position.

If you will not be using the remote control for a long time, remove the batteries to prevent corrosion.

7