Q & A
Question
How can I change the frequency?
Answer
Frequency can be changed by reconfiguring the video card.
Note that video card support can vary, depending on the version of the driver used. (Refer to the computer or the video card manual for details.)
How can I adjust the resolution? Windows ME/XP/2000 : Set the resolution at the Control
| Panel→Display→Settings. |
| * Contact the video card manufacturer for details. |
How can I set the Power Saving | Windows ME/XP/2000 : Set the function at |
function? | computer or the screen saver. (Refer to Windows/Computer |
| Manual). |
How can I clean the outer | Disconnect the power cord and then clean the monitor with a soft |
case/LCD Panel? | cloth, using either a cleaning solution or plain water. |
| Do not leave any remains of the detergent nor scratch the case. |
| Do not allow any water to go inside the monitor. |
Self-Test Feature Check
Your monitor provides a self test feature that allows you to check whether your monitor is functioning properly.
1.Turn off both your computer and the monitor.
2.Unplug the video cable from the back of the computer.
3.Turn on the monitor.
If the monitor is functioning properly, you will see a box in the illustration below.
This box appears during normal operation if the video cable becomes disconnected or damaged.
4.Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor.
If your monitor screen remains blank after using the previous procedure, check your video controller and computer system; your monitor is functioning properly.
Warning Messages
If there is something wrong with the input signal, a message appears on the screen or the screen goes blank although the power indicator LED is still on. The message may indicate that the monitor is out of scan range or that you need to check the signal cable.