Samsung LS19DOVSSY/EDC Vesa Mounting Interface, Environmental considerations, Dot Acceptable

466 x 406 x 217 mm / 18.3 x 16.0 x 8.5 inch / 6.2 kg / 13.7 lbs (With Stand) 466 x 371 x 66 mm /18.3 x 14.6 x 2.6 inch (Without Stand)

VESA Mounting Interface
100 mm X 100 mm
Environmental considerations
Operating	Temperature: 50°F to 104°F(10°C to 40°C)
	Humidity: 10% to 80%, Non-condensing
Storage	Temperature: -4 °F ~113 °F(-20 °C ~ 45 °C)
	Humidity: 5% to 95%, Non-condensing
Plug and Play Capability

This monitor can be installed on any Plug & Play compatible system. The interaction of the monitor and the computer systems will provide the best operating conditions and monitor settings. In most cases, the monitor installation will proceed automatically, unless the user wishes to select alternate settings.

Dot Acceptable

TFT LCD panel manufactured by using advanced semiconductor technology with precision of 1ppm(one millionth) above is used for this product. But the pixels of RED, GREEN, BLUE and WHITE color seem to be bright sometimes or some of black pixels could be seen. This is not from bad quality and you can use it without uneasiness.

!For example, the number of TFT LCD sub pixels contained in this product are 3,888,000.

Note: Design and specifications are subject to change without prior notice.

Class B Equipment (Information Communication equipment for residential use)

This product complies with the Electromagnetic Compatibility Directives for residential use and can be used in all areas including common residential areas.

(Class B equipment emits less electromagnetic waves than Class A equipment.)

PowerSaver

This monitor has a built-in power management system called PowerSaver. This system saves energy by switching your monitor into a low-power mode when it has not been used for a certain amount of time. The monitor automatically returns to normal operation when you press a key on the keyboard. For energy conservation, turn your monitor OFF when it is not needed, or when leaving it unattended for long periods. The PowerSaver system operates with a VESA DPMS compliant video card installed in your computer. Use the software utility installed on your computer to set up this feature.

State	Normal Operation	Power saving mode	Power off
Power Indicator	Green	Green, Blinking	Black
Power Consumption	Analog/Digital	Analog/Digital	Less than 2 W
	Less than 55 W	Less than 2 W

Preset Timing Modes

If the signal transferred from the computer is the same as the following Preset Timing Modes, the screen will be adjusted automatically. However, if the signal differs, the screen may go blank while the power LED is on. Refer to the video card manual and adjust the screen as follows.

Table 1. Preset Timing Modes
	Horizontal	Vertical	Pixel Clock	Sync Polarity
Display Mode	Frequency	Frequency
			(MHz)	(H/V)
	(kHz)	(Hz)