Samsung LS19MJQTSQ/EDC manual Answer, Self-Test Feature Check

		monitor' by searching new
		Hardware.
		MagicTune is an additional software
		for the monitor. Some graphic cards
		may not support your monitor. When
		you have a problem with the graphic
		card, visit our website to check the
		compatible graphic card list
		provided.
		http://www.samsung.com/monitor/magictune
MagicTune™ doesn't	Have you changed your	Download the latest program. The
work properly.	PC or video graphic card?	program can be downloaded
		http://www.samsung.com/monitor/magictune.

Visit our website and download the installation software for MagicTune MAC.

Check the following items if there is trouble with the monitor.

1.Check if the power cord and the video cables are properly connected to the computer.

2.Check if the computer beeps more than 3 times when booting.

(If it does, request an after-service for the main board of the computer.)

3.If you installed a new video card or if you assembled the PC, check if the installed the adapter (video) driver and the monitor driver.

4.Check if the scanning ratio of the video screen is set at 56Hz ~ 75Hz. (Do not exceed 75Hz when using the maximum resolution.)

5.If you have problems in installing the adapter (video) driver, boot the computer in Safe Mode, remove the Display Adapter at the "Control Panel→System→Device Administrator" and then reboot the computer to reinstall the adapter (video) driver.

If problems repeatedly occur, contact an authorized service center.

Q & A

Question

How can I change the frequency?

Answer

Frequency can be changed by reconfiguring the video card.

Note that video card support can vary, depending on the version of the driver used. (Refer to the computer or the video card manual for details.)

How can I adjust the resolution?

How can I set the Power Saving function?

How can I clean the outer case/LCD Panel?

Windows ME/XP/2000 : Set the resolution at the Control Panel→Display→Settings.

* Contact the video card manufacturer for details.

Windows ME/XP/2000 : Set the function at BIOS-SETUP of the computer or the screen saver. (Refer to Windows/Computer Manual).

Disconnect the power cord and then clean the monitor with a soft cloth, using either a cleaning solution or plain water.

Do not leave any remains of the detergent nor scratch the case. Do not allow any water to go inside the monitor.

Self-Test Feature Check