Beyond the Basics
time display selection
Repeatedly press DISPLAY on your remote during normal play. You will see REMAIN, TOTAL, REMAIN TOTAL on the top left side of the display.
REMAIN - Remaining playing time for the current track TOTAL - Elapsed playing time for the disc
REMAIN TOTAL - Total remaining playing time for the disc
The displayed playing times may differ slightly
Note from the times listed on the notes accompanying the disc.
program play
You can program up to 32 selections on up to three discs for play in any order.
| The same disc or track can be programmed more |
Notes | than once. |
| Load the disc that you want to program before |
| starting programmed play. |
To begin the programming procedure, select the “CD” mode.
Press PROGRAM and select DISC SELECT or DISC SKIP to select the desired disc, in CD player stop mode.
Press SKIP or the number button on the remote control to select the desired track.
Press PROGRAM to store the selected track. Repeat steps
Press PLAY/PAUSE to play the programmed tracks.
To review the programmed tracks, press PROGRAM repeatedly, in CD player stop mode.
To replace the number of the tracks you want, press PROGRAM repeatedly until the desired track appears, and repeat steps
To erase a programmed sequence at any time, press OPEN/CLOSE, or press STOP after you stop the playing.
Beyond the Basics
important information
care and maintenance
To clean the surface of the unit, simply wipe with a soft, clean cloth moistened with plain lukewarm water.
To clean the tape heads, pinch the rollers and capstans, and wipe using a cotton swab moistened with alcohol or
To clean the cassette deck, use a soft, clean moistened cloth. Never use chemical cleaners or let liquid inside the unit.
Handle your CD/CDGs with care.
If fingerprints, dust or dirt appear on your CD/CDGs, wipe with a damp cloth in straight lines from the center to the edge. Do not use detergents or abrasive cleaning agents.
warnings and cautions
The normal ventilation of this product shall not be impeded for intended use.
This CD player is made and tested to meet exact safety standards. It meets FCC requirements and complies with the safety performance standards of the U.S. Department of Health and Human Services.
This CD player uses a laser light beam. Only qualified service personnel should remove the cover or attempt to service this device, due to possible eye injury.
The use of controls, adjustments, or procedures other than those specified herein might result in hazardous radiation exposure.
The CD player is classified as a Class 1 Laser product. The label is located on the rear panel.
Invisible laser radiation when open. Avoid exposure to beam.
The CD player shall be used only in an open area.
8 | 9 |