Installing the Speakers on the Tallboy Stand
02 Connections
*
*
1.Turn the Stand Base
2.Insert small screws (4*20, For connecting Stand & Stand Base) clockwise into the four holes marked using a screwdriver as shown in the illustration.
!CAUTION : When you use a torque screwdriver, be careful not to put excessive force. Otherwise, it runs idle or can be damaged. (torque screwdriver- below 15 kg.f.cm)
3.Connect the upper Speaker to the assembled Stand.
4.Insert another large screw (5*15, For connecting Speaker & Stand) clockwise into the hole on the rear of the speaker using a screwdriver.
5.This is the appearance after the speaker is installed. Follow this steps to install other speaker.
Connecting The Speakers
1 |
Stand |
Base |
Stand |
3 |
Speaker |
Stand |
5 |
2 |
4 |
1.Press down the terminal tab on the back of the speaker.
2. Insert the black wire into the black terminal
3.Connect the connecting plugs to the back of the product by matching the
colours of the speaker plugs to the speaker jacks. | Black |
|
| Red |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
In case of HT-C450N
Centre Speaker
Front Speaker (R)
Front Speaker (L)
| VIDEO | FM AN |
| OUT |
|
DIGITAL | HDMI OUT |
|
AUDIO IN |
| |
OPTICAL |
|
|
| AUX IN | COMPONENT |
| OUT | |
Rear Speaker (R) |
| Rear Speaker (L) |
|
| |
Subwoofer |
|
|