Samsung CE109MTST1/XEG manual Troubleshooting and error code, Error Code, SE message indicates

troubleshooting and error code

TROUBLESHOOTING

If you have any of the problems listed below try the solutions given.

This is normal.

•Condensation inside the oven.

•Air flow around the door and outer casing.

•Light reflection around the door and outer casing.

•Steam escaping from around the door or vents.

The oven does not start when you press the START/+30s button.

•Is the door completely closed?

The food is not cooked at all.

•Have you set the timer correctly and/or pressed the START/+30s button?

•Is the door closed?

•Have you overloaded the electric circuit and caused a fuse to blow or a breaker to be triggered?

The food is either overcooked or undercooked.

•Was the appropriate cooking length set for the type of food?

•Was an appropriate power level chosen?

The light bulb is not working.

•The Light bulb should not be replaced in person for safety reasons. Please contact nearest authorised Samsung customer care, to arrange for a qualified engineer to replace the bulb.

The oven causes interference with radios or televisions.

•Slight interference may be observed on televisions or radios when the oven is operating. This is normal. To solve this problem, install the oven away from televisions, radios and aerials.

•If interference is detected by the oven’s microprocessor, the display may be reset.

To solve this problem, disconnect the power plug and reconnect it. Reset the time.

Sparking and cracking occur inside the oven (arcing).

•Have you used a dish with metal trimmings?

•Have you left a fork or other metal utensil inside the oven?

•Is aluminum foil too close to the inside walls?

Smoke and bad smell when initial operating.

•It’s a temporary condition by new component heating. Smoke and smell will disappear completely after 10 minutes operation.

To remove smell more quickly, please operate microwave oven with putting lemon formation or lemon juice in the cabinet.

If the above guidelines do not enable you to solve the problem, then contact your local SAMSUNG customer service centre.

Please have the following information read;

•The model and serial numbers, normally printed on the rear of the oven

•Your warranty details

•A clear description of the problem

Then contact your local dealer or SAMSUNG aftersales service.

ERROR CODE

“SE” message indicates.

•Clean the keys and check if there is water on the surface around key. Turn off the microwave oven and try setting again. If it occurs again, call your local SAMSUNG

Customer Care Centre.

“E-12” message indicates.

•The “E-12” message is Gas Sensor Short. This error may occur because of the high humidity in the cavity when you operate the microwave oven once again shortly after the previous operation of microwave oven for some food is finished. In this case, because there is a possibility that the Gas Sensor is not out of order turn off the microwave oven and try setting again. If this error occurs again, call your local

SAMSUNG Customer Care Centre.

“E-24” message indicates.

•Before the microwave can overheat, the “E-24” message appears on the display. If the “E-24” message appears, press the Stop/Eco key to utilize the initialization mode.

After the oven cools, try operating the oven. If the “E-24” message appears again, contact your local Samsung Customer Care Centre.

For any codes not listed above, or if the suggested solution does not solve the problem, contact your local SAMSUNG Customer Care Centre.

07 TROUBLESHOOTING & TECHNICAL SPEC

English - 35

CE109MTST1_XEG_DE68-04260A-00_EN.indd 35 2014-04-21 �� 5:07:28