Samsung UE55B7000WWXXH Network Connection Cable, You can connect the LAN via a Sharer Router

Network Connection

You can set up the Internet Protocol so that you can communicate with various connected networks.

❑Network Connection - Cable

■LAN Connection for a DHCP Environment

The procedures to set up the network using Dynamic Host Configuration Protocol (DHCP) are described below. Since an IP address, subnet mask, gateway, and DNS are automatically allocated when DHCP is selected, you do not have to enter them manually.

1	Connect the LAN port on the rear panel of the TV and the external modem with a LAN Cable.
2	Connect the Modem port on the wall and the external modem with a Modem Cable.

The Modem Port on the Wall	External Modem	TV Rear Panel
	(ADSL / VDSL / Cable TV)
2 Modem Cable		1 LAN Cable

You can connect the LAN via a Sharer (Router).

The Modem Port on the Wall	External Modem	TV Rear Panel
	(ADSL / VDSL / Cable TV)	IP Sharer
LAN Cable	Modem Cable	LAN Cable

You can connect the LAN port and the TV directly depending on your network status.

The LAN Port on the Wall	TV Rear Panel
	LAN Cable

■The terminals (the position of the port and the type) of the external device may differ depending on the manufacturer.

■If the IP address allocation by the DHCP server has failed, turn the external modem off, turn it on again after at least 10 seconds and then try again.

■For the connections between the external modem and the Sharer (Router), refer to the owner’s manual of the corresponding product.

■You can connect the TV to the LAN directly without connecting it through a Sharer (Router)

■You cannot use a manual-connection-type ADSL modem because it does not support DHCP. You have to use an automaticconnection-type ADSL modem.

35

English Using the Menus