Lightolier SH20330 specification

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE	INSTRUCTION SHEET NO.
This fixture is intended for installation in accordance with the National Code and local regulations.	SH20330
before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.	SH20330
To assure full compliance with local codes and regulations, check with your local electrical inspector
Retain these instructions for maintenance reference.	Page 2 0f 2

INSTRUCTIONS FOR INSTALLATION OF AGILI-T FIXTURES

Screw Wedge

End-Caps

4. Place end-caps at luminaire extremities (Figure 6) or connect next luminaire in row (Figure 7).

5. Secure end-caps or next luminaire in row by tightnening two screw wedges (Figure 6-7) of aluminum joiner (Figure 4).

Luminaire 1

Figure 6

Junction Box

Luminaire 2

Lancing

Mounting Clip	Bushing
	Strain Relief
Figure 8	Power Feed
Figure 8

Figure 9

Screw Wedge

#8 Screw		Figure 7
		Figure 7
	#8 Screw	Support to Building
		Support to Building
	J-Box Cover	Structure
	J-Box Cover

6.Locate Junction Box on mounting clip using lancings (Figure

8) and secure from inside with #8 screw provided. Pull power feed wire through bushing into J-Box, secure with strain relief and make electrical connections (Figure 9).

7.Install J-Box cover using #8 screw provided and secure J-Box to building structure as per local building codes (Figure 10).

8.Notch (1-1/2" x 1-1/2" max) and place tile (Figure 11).

9.Secure canopy using set screw provided (Figure 11).

Figure 10

Canopy

Tile

Set Screw

Figure 11

525 Education Road, Cornwall K6H 6C7

Tel:(613)938-6221 Fax:(613)938-0961

Page 2

Rev.01