Basic Connections/Auto Setup DVD/HDD View

Basic Connections/Auto Setup

DVD/HDD View

from antenna

or cable

To TV’s

Antenna Input

In this section, you will connect the DHR to your television and run Auto Setup, which automatically searches for channels and sets the

player’s internal clock.

1Connect the RF antenna cable from your indoor/outdoor antenna or cable wall outlet to the IN(FROM ANT.) jack on the rear panel of the DHR.

2Choose one of the following methods to connect the DHR to your TV:

RF Connection:

Connect the supplied RF antenna cable from the OUT(TO TV) jack on the rear panel of the DHR to your television’s Antenna Input.

Line Connection:

Connect an RCA-type audio/video cable(red, white, yellow) from the LINE OUT jacks on the rear panel of the DHR to your television’s Line In jacks.

Use red for right audio, white for left audio, and yellow for video.

➢It is recommended that you use the Line Connection if your TV is equipped with RCA jacks.

The DHR uses one set of controls to operate DVD & HDD. The following buttons are helpful in successfully controlling each one.

1Press the STANDBY/ON button on the remote control or the front panel to turn on the DHR.

2Press the DVD button on the remote control or on the front panel when you want to control the DVD deck.

•The DVD indicator will light on the Front Panel Display to show that the DVD deck is selected.

3Press again the HDD button on the remote control or on the front panel when you want to control the HDD.

•The HDD indicator will light on the Front Panel Display to show that the HDD is selected.

DVD INITIAL SCREEN	HDD INITIAL SCREEN
LOADING	AV1

3	Connect the DHR power cord to a standard 110~240V/50Hz
	wall outlet. Then power is automatically turned on.
	• Don’t press any buttons on the DHR or remote during auto setup.
	“AUTO” blinks while the DHR runs an auto setup procedure, where
	it will automatically search for all active channels.

Basic DVD Playback

Auto Setup

Auto CH Search

Audio Options

DisplayPlease OptionsWait

4	Press the STANDBY/ON button on your TV.

5	Set TV to Channel 21~69 or AV.
	Be sure to use the same channel you selected.

➢◆ Even if you plan to use the S-Video Output, you MUST connect the DHR to your television with either the standard RF or the AV Out connection.

This enables you to operate the DHR setup menu.

Follow these instructions to playback a DVD.

1	Open disc drawer.
	•	Press the Open/Close button on the remote control or front panel.

2	Insert disc.
	•	Place the disc in the drawer with the label side of the disc facing
		up. If the disc has two sides, orient the disc with the desired label
		facing up.

3	Close disc drawer.
	•	Press the Open/Close button on the remote control or front panel
		to close the disc drawer.

	46%
lnstructions	Move	Enter Return Menu Exit

4	Press the ¤ II(Play/Pause) button on the remote control or front
	panel.
	•	Many discs will begin playback automatically when the disc drawer
		closes.
	•	If the DVD has a disc menu, or more than one title, the disc menu
		may appear.

5	Additional DVD options.

•See pages 45~56.