Samsung MM-DT8R/ELS manual Press REV.MODE until the appropriate symbol is displayed, Power

Page 27

Selecting the cassette Playback Mode/Repeat A↔ B Function

Timer Function

• The timer enables you to switch the system on or off at specific times.

• If you no longer want the system to be switched on or off automatically, you must cancel the timer.

• Before setting the timer, check that the current time is correct.

• For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.

Selecting the Cassette Playback Mode

Your micro component system has three cassette playback modes which enable you to listen to both sides of a cassette automatically.

Press REV.MODE until the appropriate symbol is displayed.

Example: You wish to wake up to music every morning.

Switch the system

Press

TIMER/CLOCK

on by pressing

until TIMER is

1 POWER.

2 displayed.

Press the ENTER

3 button.

•ON TIME is displayed (instead of the equalizer symbols) for a few seconds, followed by any switch-on time already set; you can set the timer switch-on time.

•When the display indicates...The micro component system plays back

One side of the selected cassette and then stops.

One side of the cassette.

The other side of the cassette and then stops.

Both sides of the cassette indefinitely until you press stop.

REPEAT A↔ B Function

4 Set the timer switch-on time.

a. Set the hour by pressing or button.

b. Press ENTER.

•The minutes flash.

c.Set the minutes by pressing or button.

d.Press ENTER.

•OFF TIME is displayed (instead of the equalizer symbols) for a few seconds, followed by any switch- off time already set; you can now set the timer switch-off time.

5 Set the timer switch-off time.

a. Set the hour by pressing or button.

b. Press ENTER.

•The minutes flash.

c.Set the minutes by pressing or button.

d.Press ENTER.

•VOL 20 is displayed, where 20 corresponds to the volume already set.

Press or button

6 to adjust the volume level and press

ENTER.

•The source to be selected is displayed.

Press REP. A↔ B button.

•Use this to listen to a specific section again during playback.

•Set the start and end points of the section you want to repeat 3 times.

•This is a useful when learning a foreign language.

•The TAPE REPEAT function can be used only on sections that are longer than 7 seconds.

Note

• You cannot set the end point (B) within 7 seconds after

 

setting the start point (A).

51

Press or button

8

Press ENTER to

to select the source to

confirm the timer.

be played when the

 

7 system switches on.

 

•TAPE (cassette) : Insert a cassette tape.

•TUNER (radio) : a Press ENTER. b Select a preset

station by pressing Tuning or .

•CD (compact disc) : Load a compact disc.

•USB : Connec the usb.

Note

• If the timer switch on and off times are identical, the word ERROR is displayed.

Press POWER to

9 set the system to standby mode.

• is displayed to the top-right of the time, indicating that the timer has been set.

•The system will switch on and off automatically at the required times.

52

MISCELLANEOUS

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Personal Micro Component System Precautions Safety WarningsContents Front Panel DescriptionInsert Remote Batteries Range of Operation of the Remote ControlConnecting to a TV Connecting the SpeakersAmmw antenna connection FM antenna connectionSelecting the Video Format Setting the ClockWhen the correct Time is displayed, press Enter Press ENTER. The hour flashesPresstray. OPEN/CLOSE button to close the disc Disc Playback MP3/WMA-CD PlaybackTo play a file icon in the screen Press OPEN/CLOSE button to open the disc tray Load a discDivX Playback Slow Playback Fast/Slow PlaybackDisplaying Disc Information Fast Playback DVD VCD CD MP3Playing Frame by Frame DVD Skipping Scenes/SongsAngle Function Briefly press buttonPress Info button twice To Select a Repeat Playback Mode Disc Information ScreenRepeat Playback Press Repeat buttonPress REP. A↔ B Repeat Playback Zoom FunctionZoom Screen Enlarge Function Aspect Ratio DVD1Press Info button Press Info button Press Cursor Button to move to TwicePress the numeric buttons Slide Mode Digest Function Jpeg File Playback JpegRotate/Flip Function Using the Title Menu Using Disc MenuPress Menu button to exit the setup screen Language Code ListSetting the Language Stop modeAdjusting the TV Aspect Ratio Screen Size Setting TV Screen typeSetting the Password 1Press Menu button in the stop mode1Press Menu button Stop mode Button Setting the Wallpaper Jpeg DVD VCDSetup screen 1PLAY/PAUSE button when the image you like comes upIf DRC is selected AV Sync SetupPress Cursor , to adjust the ‘DRC’ Press the Menu buttonPlease be aware of the following before using USB Playing USBSelecting a Track from USB Device Main Unit Tune in to the desired station Remote Control Unit To use high speed search Listening to RadioPresetting Stations About RDS broadcasting1TUNERBAND button and select the FM band Press Tape on the player to select the Tape function Switch the system on by pressingListening to a Cassette PTY Program Type indication and PTY-SEARCH functionPower Press REV.MODE until the appropriate symbol is displayedInsert a blank cassette in Deck Canceling the TimerSwitch the system On by pressing Recording a Compact DiscTo stop recording, press button Recording a Radio ProgramREC/ Pause button 5Press REC/PAUSEPress Multi Jogpush Enter button until Bass 00 is displayed Press Multi Jogpush Enter button until Treb 00 is displayedPress DEMO/DIMMER button Connecting HeadphonesTo cancel this function, press Demo / Dimmer FunctionBefore Calling for Service Aspect ratio cannot be Symptom Check/Remedy Audio languagePassword for rating Subtitles do not workAngle SpecificationsUSB Feature Supported Player Europe only
Top Page Image Contents