Samsung HTDB760TTH/FES Before Calling for Service, Symptom Check/Remedy Disc tray does not open

Page 67

33P~70P(DB760)-GB-nords 1/3/04 2:59 PM Page 64

Before Calling for Service

Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below or if the instruction below does not help, turn off the unit, disconnect the power cord, and contact the nearest authorized dealer or Samsung Electronics Service Center.

Symptom

Check/Remedy

Disc tray does not open.

Is the power cord plugged securely into the outlet?

 

Turn off the power and then turn it back on.

 

 

 

 

 

 

 

 

 

Playback does not start.

Check the region number of the DVD.

DVD discs purchased from abroad may not be playable.

 

CD-ROMs and DVD-ROMs cannot be played on this DVD

 

player.

 

Make sure that the rating level is correct.

 

 

 

 

 

 

 

 

 

Playback does not start

Are you using a deformed disc or a disc with scratches on

immediately when the

the surface?

Play/Pause button is pressed.

Wipe the disc clean.

 

 

 

 

 

 

 

 

 

Sound is not produced.

No sound is heard during fast playback, slow playback, and step

motion playback.

 

Are the speakers connected properly? Is the speaker setup

 

correctly customized?

 

Is the disc severely damaged?

 

 

 

 

 

 

 

 

 

Sound can be heard only

When listening to a CD or radio, sound is output to the front

speakers (L/R) only. Select "PRO LOGIC II" by pressing

 

 

 

 

 

 

 

 

 

 

from a few speakers and

(Dolby Pro Logic II) on the remote control to use all six speakers.

not all six.

Make sure that the DVD disc is 5.1-CH compatible.

If you set C, SL, and SR to NONE in the speaker mode in the

 

audio setup of the setup screen, no sound is heard from the

 

center speaker and the front left and right speakers. Set C, SL,

 

and SR to SMALL.

 

 

 

 

 

 

 

 

 

Picture does not appear, sound

Was the DVD player suddenly moved from a cold place to a warm

is not produced, or the disc

one? When condensation forms inside the player, remove the disc

and let the player stand for 1 or 2 hours with the power on. (You

tray opens 2 to 5 seconds later.

can use the player again after condensation disappears.)

 

 

 

 

 

 

 

 

 

Dolby Digital 5.1 CH

Is there "Dolby Digital 5.1 CH" mark on the disc? Dolby Digital 5.1

Surround Sound is not

CH Surround Sound is produced only if the disc is recorded with

5.1 channel sound.

produced.

Is the audio language correctly set to DOLBY DIGITAL 5.1-CH in

 

the information display?

 

 

 

 

 

 

 

 

 

65

Image 67
Contents This Appliance is Manufactured by Digital Home Cinema System Class 1 Laser Product Safety WarningsPreparation PrecautionsMulti-Disc Playback & AM/FM Tuner FeaturesContents Copy Protection Playable DiscsDisc Recording Format Front Panel DescriptionRear Panel Remote Control Insert Remote Batteries Position of the DVD Player Selecting the Listening Position Connecting the SpeakersBack of the Speaker Screws B as shown in the illustration Mounting the Speakers to a WallComposite Video Good Quality Connecting the Video to TVFM antenna connection Connecting the AntennasCooling Fan AMMW/LW antenna connectionConnecting an External Digital Component Connecting External ComponentsPress AUX on the remote control to select AUX 1 or AUX Connecting an External Analog ComponentSelecting the Video Format Press the Mode Button so thatTo stop playback Press Stop during playback Disc PlaybackDisc tray Load a discsPress Info button Displaying Disc InformationPress the Remain button Checking the Remaining TimePress and hold Fast/Slow PlaybackPress Slow button Briefly press Skipping Scenes/SongsPress Repeat button Repeat PlaybackPress Enter Press Info button twicePress Cursor Angle FunctionPress EZ View button Zoom FunctionPress Zoom ButtonPress Info button Press Cursor Button to move to Twice 1Press Info button twiceChapter display 1Press Info buttonPress Cursor , buttons Time displayButtons to Using Disc MenuButton ‘Title Menu’ Using the Title MenuPress Menu button to exit the setup screen Press MenuSetting the Language Press Enter button Press Enter Press CursorDISPLAY’ and then Setting TV Screen typePress Enter button Wide Adjusting the TV Aspect Ratio Screen SizeSetting Parental Controls Rating Level Press Cursor , button Enter the passwordPress Cursor Button to move to Press Menu button Setting the PasswordButton Enter button During playback, press Setting the Wallpaper Jpeg DVD VCDTo Change the Wallpaper ‘Setup’ and thenSpeaker Setting the Speaker ModePress Enter button Press Cursor ‘Audio’ and then Setting the Test TonePress Test Tone button Press Cursor button Setting the Delay Time3to move to ‘DELAY TIME’ and then press Enter button Enter button Press Cursor button Setting the Audio QualityPress Sound Method 2 When manually adjusting with the Sound Edit buttonSetting the DRC Dynamic Range Compression ‘DRC’ and then press Enter button Press PL II Mode button Dolby Pro Logic II ModePress PL II Effect button Press PL II ModeButton to select ‘MUSIC’ mode Dolby Pro Logic II EffectSetting the RRSSRear Reflecting Surround System Next,briefly press the Rrss button To cancel the Rrss setupBriefly press the Rrss button Press and hold the Rrss buttonTo cancel the rear What is RRSS?Each time you press the LSM + Live Surround ModeSurround Plus / Virtual Headphone To cancel the surround plusSuper To cancel thisPress the Super Button to select Main Unit Remote Control Unit Press TunerListening to Radio Band buttonPresetting Stations Convenient Functions To confirm the sleep timer setting, press Sleep buttonPress Sleep button Press Mute button Press Dimmer buttonWhen operating the TV with the remote control Operating the TV with the Remote ControlBrand Code TV Brand Code ListSymptom Check/Remedy Disc tray does not open Before Calling for ServiceAudio language Disc Storage Handling discsHandling and Storing Discs 1ch speaker system SpecificationsNumber Memo