Washing a Load of Laundry
Overview of the control panel
1.Digital graphic display
Displays the remaining wash cycle time, all of washing information and error messages.
2.Air Wash button
Use to remove bad smells.
Selected in the sequence: Suit/Jumper Knit Coat Bedding Cancel
3. Wash selection button ( 
)
Use this to only perform washing or prewash.
Selected in the sequence: Main Wash Prewash + Main Wash Main Wash.
The washing time cannot be adjusted (for the Cotton course).
Prewash can only be selected for Cotton, Intensive, Boil,
4.Temperature selection button
Selected in the sequence: 40˚C 60˚C Cold 40˚C.
The water temperature varies depending on the course.
Do not allow only hot water to be supplied.
5.Rinse selection button ( 
)
Select this to add a rinse cycle or only perform the rinse cycle.
You can select this up to 5 times.
6.Spin selection button ( 
)
You can select the spin speed, if necessary.
If only the spin cycle is selected and Start/Pause is pressed in the middle of the spin cycle, the machine starts spinning from the beginning.
The spin speed can vary, depending on the course.
No Spin means no spinning is performed after the drain.
7.Dry selection button
Selected in the sequence: Cupboard Extra Iron Light Time (30min 1:00min 1:30min
2:00min 2:30min) Cupboard.
8.Silver Wash button ( 
)
Silver water is supplied in the wash cycle as well as the last rinse, featuring sterilization and antibacterial coating.
WD6122CK-02384L_EN.indd 2
