Selecting the Heat Mode
You can select the Heat mode if you want to heat your room. You can adjust the temperature and the fan speed when heating.
1If necessary, press the 
(On/Off) button.
Result: The operation indicator on the indoor unit lights up. The air conditioner starts up in the mode you selected last. The indoor unit beeps.
2Press the 
button on the remote control until 
is displayed.
Result: The indoor unit beeps each time you press the | button. |
The air conditioner runs in the Heat mode. |
|
Note You can change modes at any time.
3Press the 
button to adjust the temperature until the required temperature is displayed.
You can set the temperature between 16°C and 30°C.
Result: Each time you press the 
button:
-The temperature is adjusted by 1°C
-The indoor unit beeps
If the room temperature reaches 5°C higher than the set temperature, the air conditioner stops heating, but the fan operates consistently.
If the room temperature reaches 3°C lower than the set temperature, the air conditioner starts heating again.
4 Press the | button to select the fan speed until the required settingis |
displayed. |
|
Automatic (rotated : 
)
Low
Medium
High
Maximum
Result: Each time you press the 
button, the indoor unit beeps. For the first 3~5 minutes, the fan may not operate to prevent
the cool air from running out of the indoor unit. It helps to warm the air in your room sufficiently.
5To control the airflow direction, refer to pages 16 and 17.
ENGLISH
AQ30_36W_IB_E_28061A.indd 11