Washing a Load of Laundry
Washing clothes manually
You can wash clothes manually without using the Fuzzy Logic feature.
To do so:
1.Turn the water supply on.
2.Press the 
(On/Off) button on the washing machine.
3.Open the door.
4.Load the articles one at a time loosely into the drum, without overfilling.
5.Close the door.
6.Put the detergent and, if necessary, softener or prewash detergent, in the appropriate compartments.
7.Press the Temperature button to select the temperature. (cold water, 30˚C, 40˚C, 60˚C, 95˚C)
8.Press to rinse button to select the required number of rinse cycles. Maximum number of rinse cycles is five.
The washing duration will be prolonged accordingly.
9.Press the Spin button to select the spin speed. [ 
, 
, 400, 800, 1000, 1200 , … revolutions per minute(rpm)]
Notice: The rinse hold program allows you to take clothes that are dripping wet out of the washing machine.
: No Spin | : Rinse Hold |
10.Press the button repeatedly to cycle through the available delayed start options (from 3 hour to 24 hours in one hour increments). Displayed hours means the time of finished
11.Press the Start/Pause button and the machine will begin the cycle.
Using delay start
You can set the washing machine to finish your wash automatically at a later time, choosing from 5 to 24 hour delay (in 1 hour increments). Displayed hours means the time of finished
To do this:
1.Manually or automatically set your washing machine for the type of clothes you are washing.
2.Press the Delay Start button repeatedly until the delay time is set.
3.Press the Start/Pause button. The Delay Start indicator will light, and the clock will begin counting down until it reaches your finish time.
4.To cancel Delay Start, press the 
(On/Off) button, then turn the washing machine on again.