Samsung MM-E320/UM manual Control until FM XX is displayed, Press , button on the top panel or

Listening to Radio Selecting a Stored Station

You can store up to:15 FM stations.

1.Press FUNCTION to select FM mode.

To search	Press TUNING MODE button
for a
station

You can listen to a stored radio station as follows:

1.	Press FUNCTION to select FM mode.
2.	Press the TUNING MODE button on the remote
	control until “FM XX” is displayed.
3.	Press [,] button on the top panel or

2.

Preset ...

Manually ...

Once or more times until “FM XX” is displayed. You can search the stored frequencies in the Preset mode. Once or more times until “MANUAL” is displayed.

You can search the frequencies one by one in the manual mode.

TUNING/ALBUM , , . on the remote

control to select a desired preset number.

Setting the Clock

3.Select the station in any of the following ways:

◆◆Press the TUNING/ALBUM , or . button on the remote control.

◆◆To fast scan for a frequency manually, press and hold the TUNING/ALBUM , or .button.

4.Press MO/ST to switch between stereo and mono.

•In a poor reception area, select MONO for a clear, interference-free broadcast.

•This applies only when listening to an FM station.

5.If you don’t want the preset, move back to step 3 and select a different preset.

Otherwise,

a.Press ENTER.

b.Or, press the [,] button on the top panel or TUNING/ALBUM , or . button on the remote control to select a program number.

c.Press ENTER to save the preset.

6.To save other radio frequency, repeat steps 2

through 5 above.

In Tuner Mode

•To scan for radio frequencies in manual mode, use the [,] buttons on the top panel.

•To stop scanning, press STOP (@).

•To scan for a preset in preset tuning mode, use the [,] buttons.

For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.

1.Switch the system on by pressing the POWER button.

2.Press TIMER/CLOCK button and then press the ENTER button,"CLOCK” is displayed.

3.Press ENTER,the hour flashes.

●●Increase the hours:,.

●●Decrease the hours:..

4.When the correct hour is displayed, press ENTER, the minutes flashes.

●●Increase the minutes:,,

●●Decrease the minutes:..

5.When the correct minute is displayed, press ENTER, "TIME" appears in the display.

●● The current time is set now.

●●You can display the time, even when you are using another function, by pressing the TIMER/CLOCK button once.

●●You can also use [ or ] on the top panel instead of TUNING/ALBUM ,or . buttons in step 3,4.

10English