installation & maintenance
The User’s Manual is for common use. Make use of the User’s Manual depending upon your washing machine model.
ENVIRONMENT
Leave some space - Maintain at least 10cm between the washer and the wall.
Place the washer on a sturdy flat surface. - If the washer is placed on an uneven or weak surface, noise or vibration occurs. (Allowable is 1°) Adjust the legs for even placement.
Never install the washer near water. - Do not place the washer in steamy rooms or where the washer is directly exposed to rain. Moisture may destroy the electrical insulation causing an electrical shock hazard.
Avoid direct sunlight or heaters. - As plastic an electrical components are affected by direct heat, never place the washer near furnaces, boilers, etc. Do not place under direct sunlight.
LEVELLING
If the washer is not leveled with the ground, it makes the machine tremble more or be out of order. So, make sure that the washer is leveled properly.
SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING THE POSITION OF THE WASHING TUB.
• Open the lid of the machine, pour water into the tub up to the level | Water |
just below the pulsator, and adjust the legs so that the pulsator is |
|
positioned at the center of the water as shown in the figure. |
|
• Place the machine more than 10 cm away from the wall.
• Adjust the legs on feet for levelling. |
|
| ||
CONNECTING THE WATER SUPPLY HOSE | LOOSEN | LOCK | ||
|
| |||
1. Remove the adaptor from the |
| 4. Connect the water supply hose to | ||
water supply hose. |
| the adaptor. Pull down the part (c) | ||
|
| of the water supply hose. When | ||
| c | the part (c) is released, the hose | ||
|
| is automatically connected to the | ||
|
| adaptor making a ‘click’ sound. | ||
2. First, using a “+” type screw | a | 5. Connect the other end of the | ||
driver, loosen the four screws | water supply hose to the inlet | |||
| ||||
on the adaptor. Next, take the | 5 mm | water valve at the back of the | ||
adaptor and turn part(b) following | b | washer. Screw the hose clockwise | ||
| ||||
the arrow for gap about 5 mm |
| all the way in. |
| |
between them. |
|
|
| |
3. Connect adaptor to the water tap |
| |||
by tightening the screws firmly. | a | water supply hose to the inlet | ||
Then, turn part(b) following the | b | water valve at the top of the | ||
| ||||
arrow and put (a) and (b) together. |
| washer. Screw the hose clockwise | ||
|
| all the way in. |
| |
• If the water tap is a screw type, assemble a water supply hose that fits to the tap as shown. After completing connection, if water leaks from the hose, then repeat the same steps.
After completing connection, if water leaks from the hose, then repeat the same steps.
Use the most conventional type of faucet for water supply. In case the faucet is square or too big, remove the spacing ring before inserting the faucet into the adaptor.
installation & maintenance_11
11:58:39