Waterdrop mark | Cause | How to level |
|
|
|
| The front part is | Level it by adjustable legs. |
| lower | |
|
| |
|
|
|
| The back part is | Adjust the height by using the adjustable rubber |
| lower | or prop at the back. |
|
|
|
| The left part is | Adjust the left part by using the adjustable legs |
| lower | at the front and the adjustable rubber at the back. |
|
| |
|
|
|
| The right part is | Adjust the right part of the washer by using the adjustable leg |
| at the front and the adjustable rubber at the back. | |
| lower | |
|
| |
|
|
|
WATER SUPPLY CONNECTOR FILTER
1.Pull out the filter and wash well.
inlet water valve
2.Pull in the filter and connect the hose to the inlet water valve tightly.
3.Check if there is a leakage. Note to tighten up the connector.
HOW TO PUT THE DETERGENT IN AND ADD THE FABRIC SOFTENER
1.Open the detergent box by pulling in the direction of the arrow as shown in the
figure and then put the powder detergent in the detergent box. |
|
2. Put in | may not brim over the box. |
Detergent Device | Softener Device |
Put the detergent |
|
in proportion to |
|
water level |
|
Softener Device |
|
Softener |
|
baseline |
|
•When a proper amount (one time does) of fabric softener is stored in the softener inlet,it is automatically put in at the last rinsing cycle.
•Do not use detergent, bleach or starch into the Softener Inlet.
•Using too much softener may produce unsatisfactory results.
•Do not open the lid during the Spin Dry cycle.
If added too early, its effectiveness will decrease.
•Do not leave the softener into the Softener Dispenser for a long time. Because softner became stiff.
CAUTION : If softener is stored over the above base line, it may flow down at any time.
9