Samsung RSH3FTPE1/JUM, RSH1NTSW1/ZAM, RSH3FTPE1/MTR manual Warranty Information

4.Remove the filter’s protective cap and then position and insert the filter into the filter housing.

5.Slowly turn the water filter clockwise 90º to align with the indication mark on the cover, locking the filter in position. Make sure that the indicator is lined up with the “lock” position. Remember, do not over-tighten.

If your model contains wine shelf, you should remove the wine shelf before installing water filters.

Cover filter

Separation	Align the indication
of red cap	mark with lock position

instaLLing tHE watEr DisPEnsEr LinE

For Interior model

Parts for water line Installation

			Purifier lock
Water line fixer and	Pipe	Water line	station
			Tightening band
screws	connector			Purifier

Connecting to the water supply line

Connect the water pipe with coupler and tap.

1.Close the main water tap.

2.Connect coupler “A” to the tap. Note:

CAUTION

The water line must be connected to the cold water pipe. If it is connected to the hot water pipe, it may cause the purifier to malfunction.

WARRANTY INFORMATION

This water line installation is not covered by the	COUPLER “A”
refrigerator or ice maker manufacturer’s warranty.
Follow these instructions carefully to minimise the risk of
expensive water damage.

Note:

If the coupler does not fit on the current tap, go

the nearest authorised service dealer and purchase the right couplers fittings.

select the location where the purifier is to install. (Model with the purifier)

-If you wish to reassemble the water inlet and outlet sides of the purifier during purifier installation, see the reference illustration.

-Cut the water line attached to the purifier to the appropriate place after measuring the distance between the purifier and the cold water tap.

		TAP
	LINE
	OUTLET
SIDE OF		90 degree
PURIFIER
PURIFIER WATER		REFERENCE
WATER INLET	COUPLER
SIDE OF PURIFIER

20_ setting up