MP3 Encoding
1 Connect the Audio Output port on the external audio source (or the Line Out port) to the ENC port on the device with the Line cable.
2 | Slide the | switch to the ENC position begin MP3 encoding. |
REC/ENC
3 REC/ENC
Slide the 
switch to the REC position while recording to stop
the encoding, and a new encoding file will be created.
●Recording will take place in the order of L001, L002, L003… . When the recording is finished, the files will be saved as MP3 files.
Note :
●Bit Rates can be set within the range of 32Kbps~128Kbps.
●To pause during Encoding, press the 
button. Press the button once again to recommence recording.
●Volume can be adjusted from level 0 to 10 while monitoring the Encoding.
Notice :
●Do not disconnect the Line cable during Encoding.
●If the battery is not charged enough, encoding will not be done.
●Adjust the volume of the external audio source to a suitable level and encode it. If the volume level is extremely high, the sound quality may not be good.
36 | 37 |