Samsung HT-D455K/XV, HT-D453HK/XV manual Installing the Speakers on the Tallboy Stand, English 1

Installing the Speakers on the Tallboy Stand

02

*HT-D453K only - Front Speakers

*HT-D455K only - Front/Surround Speakers

1.Turn the Stand Base upside-down and connect it to the Stand.

2.Insert small screws (4*20, For connecting Stand & Stand Base) clockwise into the four holes marked using a screwdriver as shown in the illustration.

!CAUTION : When you use a torque screwdriver, be careful not to put excessive force. Otherwise, it runs idle or can be damaged. (torque screwdriver- below 15 kg.f.cm)

3.Connect the upper Speaker to the assembled Stand.

4.Insert another large screw (5*15, For connecting Speaker & Stand) clockwise into the hole on the rear of the speaker using a screwdriver.

5.This is the appearance after the speaker is installed. Follow this steps to install other speaker.

Installing the Speakers on the Half Tallboy

1

Stand

Base

Stand

3

Speaker

Stand

5

2

4

*HT-D453HK only - Front Speakers

1.Stretch out the speaker cables as shown and arrange it through the hole of the stand base.

2.When done, use the screw driver to tighten the screw

(C) in each of 3 screw holes as shown.

3.This is the appearance after the speaker is installed. Follow these steps to install other speaker.

1 2

3

English 1