Samsung BF1C4T043/BOL, BF1C6G043/BOL manual Installation in the cabinet

Installation in the cabinet

With built-in furniture, plastic surfaces and adhesive for the oven should be resistant to 90 °C inside of the furniture and to 75 °C for adjacent furniture. Samsung will take no responsibility for damage of plastic surfaces or adhesive from the heat.

There should be a ventilation gap in the base of the kitchen cabinet where the oven is to be placed. For ventilation, a gap of about 50 mm should be left between the lower shelf and the supporting wall. If the oven is to be installed below a hob, the hob’s installation instructions should be followed.

		Min.550		Min.560
				Min.50
	370		560
Max.50				Min.590 ~ Max.600
595		572	550
	595	545
		21
				Min.460 x Min.50
Built-in

		Min.550		Min.560
370		175	560
	115
595				Min.600
Max. 476			572 550
595	Max.		545	Min.460 x Min.50
	464	21		Built-under
				Built-in + Built-under

Push the appliance completely into the cabinet and fix the oven firmly on both sides using 2 screws. Make sure that a gap of at least 5 mm should be left between the appliance and the adjacent cabinet.

After installation, remove the vinyl protective film, tape, paper and accessories from the door and inside of oven. Before uninstalling the oven from the furniture, disconnect the oven from the power supply and release the 2 screws on the both sides of the oven.

WARNING: The built-in furniture must have a minimum ventilation gap for Air-flow as shown on picture. Do not cover this hole with strips of wood, for this is used to provide ventilation.

The front exterior of the oven such as handle is different model by model. But the size of the oven in the picture is same.

English - 10

BF1C4T043_BOL_DG68-00069K-05_EN.indd 10

2015-03-13 �� 4:58:17