WATER SUPPLY CONNECTOR FILTER
| inlet water |
|
| valve |
|
1.Pull out the filter and wash well. | 2. Pull in the filter and connect | 3. Check if there is a leakage. |
| the hose to the inlet water | Note to tighten up the |
| valve tightly. | connector. |
CLEANING THE FILTER NET Clean the filter net often to keep the washer clean.
1. Push the upper part | 2. Open the cover as | 3. Clean the filter. | 4. Close the cover and insert the |
of the filter and pull in. | shown in the figure. |
| lower part of the filter in the |
|
|
| basket first and then push the |
|
|
| filter with "click" sound . |
|
|
|
|
HOW TO CLEAN THE FILTER
1. Place a rag under the washer filter not to wet the floor.
2. Rotate the filter counterclockwise and pull out the filter.
3. Remove dirts and rotate
the filter clockwise until it locks in position.
(pump drained washer)
1.Place a rag under washer filter not to wet the floor.
2.Turn the
3.Take the filter out and
remove dirts. 4. Reassemble in
reverse order.
HOW TO ASSEMBLE THE LEGS 
1. Check the 4 |
| Hook | |
| Hole | ||
2. Lay down the Washing Machine to the front. |
| ||
3. Insert the hook of leg in to the square hole | | | |
of base. | |||
| |||
4. Push the leg to the arrow direction to “Click”. |
| Base | |
5. Finaly fix the legs on the base |
|
| |
with screw like a figure. |
| Screw | |
|
|
9