3.After adjusting the doors, turn the nut 1 clockwise 
until it reaches the lower end of the bolt, then tighten the bolt again with the wrench 3 to fix the nut in place 1 .
3 Wrench
2 Bolt
1 Nut
If you do not secure the nut firmly, the bolt may release.
CHECKING THE WATER DISPENSER LINE
A water dispenser is just one of the helpful features on your new Samsung refrigerator. To help promote better health, the Samsung water filter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You will need to purchase a water purifying system to do that.
In order for the icemaker to operate properly, water pressure of 138 ~862 Kpa is required. Under normal conditions, a 170 cc paper cup can be filled in 10 seconds.
If the refrigerator is installed in an area with low water pressure (below 138 Kpa), you can install a booster pump to compensate for the low pressure.
Make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water outlet.
Water Line installation Kits are included with unit. You can find it in freezer drawer.
Parts for water line Installation
1 | Water line fixer | 2 | Pipe | 3 | Water Line | 4 Water line | 5 Water Filter |
| and screws |
| connector |
| protection tube |
|
|
Connecting to the water supply line
1.First, shut off the main water supply line.
2.Locate the nearest cold, drinking water line.
3.Follow the Water Line Installation Instructions in the installation kit.
Close Main |
Water pipe |
Close Main |
Water pipe |
No gap |
4.After connecting the water supply to the water filter, turn your main water supply back on and Dispense about 1L to clear and prime the water filter.
18_ setting up