INSTALLING OF THE WATER DISPENSER LINE
For Interior Model (Case 1)
Connecting to water supply line
- Shut off the main water supply line and turn the Ice maker to the off position.
- Locate the nearest cold drinking water line.
- Follow the instructions in the ice maker installation kit.
1.Cold Water line
2.Pipe Clamp. 3.Copper (or Plastic) line 4.Compression Nut 5.Compression Sleeve 6.Shut Off Valve 7.Packing Nut.
Connect the water line to the refrigerator
-Slip the compression nut and plastic ferrule through the plastic tube.
-After inserting the sleeve, tighten the compression nut onto 1/4” compression fitting(union).
Do not overtighten the compression nut.
NOTE
-Slip the compression ferrule and nut on copper(or plastic) tubing as shown.
Tighten the comperssion nut onto the compression fitting(union).
- Turn water on and check for any leakege.
Compression
Nut
Ferrule
Sleeve
Compression fitting
Ferrule
Compression
Nut
Waterline must be connected to drinkable water only
NOTE
(Case 2)
Check the water supply line
Connect the water pipe with coupler and tap.
-Close the main water tap.
-Connect coupler “A” to the tap.
-Every join should be protected with sealing tape.
WARRANTY INFORMATION
This water line installation is not covered by the refrigerator or ice maker manufacturer's warranty.
Follow these instructions carefully to minimise the risk of expensive water damage.
Note:
If the coupler does not fit on the current tap, go
the nearest authorised service dealer and purchase the right couplers fittings.
CAUTION
The water line must be
to the cold water pipe.
If it is connected to the hot water
pipe, it may cause the purifier to malfunction.
COUPLER “A”
TAP
28