Installing your microwave oven

PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY

Failure to observe the following safety precautions may result in harmful

Place the oven on a flat level surface 85 cm above the floor. The surface should be strong enough to safely bear the weight of the oven.

ENGLISH

exposure to microwave energy.

(a) Under no circumstances should any attempt be made to operate the

oven with the door open or to tamper with the safety interlocks (door

latches) or to insert anything into the safety interlock holes.

(b) Do not place any object between the oven door and front face or allow

food or cleaner residues to accumulate on sealing surfaces. Ensure that

1.When you install your oven, make sure there is adequate ventilation for your oven by leaving at least 10 cm (4 inches) of space behind and, on the sides of the oven and 20 cm (8 inches) of space above.

20 cm	10 cm
above	behind
85 cm of	10 cm on
the floor	the side

the door and door sealing surfaces are kept clean by wiping after use

first with a damp cloth and then with a soft dry cloth.

qualified microwave service technician trained by the manufacturer. It is

particularly important that the oven door closes properly and that there

is no damage to the:

(1) Door (bent)

(2) Door hinges (broken or loose)

(3) door seals and sealing surfaces

(d) The oven should not be adjusted or repaired by anyone other than

a properly qualified microwave service technician trained by the

manufacturer.

This product is a Group 2 Class B ISM equipment. The definition of group 2 which contains all ISM equipment in which radio-frequency energy is intentionally generated and/or used in the form of electromagnetic radiation for the treatment of material, and EDM and arc welding equipment.

For Class B equipment is equipment suitable for use in domestic establishments and in establishments directly connected to a low voltage power supply network which supplies buildings used for domestic purposes.

2.Remove all packing materials inside the oven. Install the roller ring and turntable.

Check that the turntable rotates freely.

3.This microwave oven has to be positioned so that plug is accessible.

If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent.

For your personal safety, plug the cable into a 3-pin, 230 Volt, 50 Hz, AC earthed socket. If the power cable of this appliance is damaged, it must be replaced by a special cable.

Do not install the microwave oven in hot or damp surroundings like next to a traditional oven or radiator. The power supply specifications of the oven must be respected and any extension cable used must be of the same standard as the power cable supplied with the oven. Wipe the interior and the door seal with a damp cloth before using your microwave oven for the first time.