Demo/Dimmer function |
| Setting the Clock |
|
|
|
|
|
|
GB
All functions available on the system can be viewed on the display and the display's brightness can be switched between "on" and "off".
1 | Press the Demo/Dimmer button. | ||||||||||||||
|
| Result: All functions available on the system appear on the front | |||||||||||||
|
|
| panel display. | ||||||||||||
|
| Each of these are explained in detail in this guide. Please refer to | |||||||||||||
|
| the relevant section. | |||||||||||||
2 | Press the Demo/Dimmer button again. | ||||||||||||||
|
| Result: The Dimmer function is selected and the display darkens. | |||||||||||||
|
| Press the Demo/Dimmer button once again to brighten the front | |||||||||||||
|
| panel display. | |||||||||||||
3 | A display brightness control can only be performed while the | ||||||||||||||
|
| system power is on. | |||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Your system is equipped with a clock which allows you to turn your system on and off automatically. You should set the clock:
When you first purchase the
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.
1 Switch the system on by pressing Standby/On.
2 Press Timer/Clock twice. Result: CLOCK is displayed.
3 Press Enter.
Result: The hour flashes.
4 | To... | Turn the Multi Jog knob to the... |
| Increase the hours | Right |
| Decrease the hours | Left |
5 | When the correct hour is displayed, press Enter. | |
| Result: The minutes flash. |
|
6 |
|
|
To... | Turn the Multi Jog knob to the... | |
| Increase the minutes | Right |
| Decrease the minutes | Left |
7 | When the correct time is displayed, press Enter. | |
| Result: The clock starts and is displayed, even when the system is in |
standby mode.
You can display the time, even when you are using another function, by pressing Timer/Clock once.
You can also use Program/Set button on the remote control to instead Enter button in step 3, 5, 7.
You can also use / buttons to instead Multi Jog knob in step 4, 6.
2 |
1 |
3,5,7 |
4,6 |