When you have purchased the wireless receiving module
Resetting Wireless Communication
Connecting the Video Out to TV | BG |
|
Choose one of the three methods for connecting to a TV.
Reset the system if a communication failure occurs, or if the Link indicator (blue LED) on the wireless receiver does not light up and the "REAR CHK" message blinks on the main unit's display.
Reset the system while the main unit and the wireless receiver module
1 With the main unit turned off, press and hold the remote control's REMAIN button for 5 seconds.
• Press the button until the POWER( 
) indicator lights up blue. (The indicator will turn off in 1 second.)
2 With the wireless receiver module turned on, use a ball point pen or a pair
of tweezers to press the RESET button WIRELESS RECEIVER MODULE on the back of the unit.
•The Standby/On LED on the front panel of the wireless receiver module blinks 2 times.
3 Turn on the main unit.
• The Link LED of the wireless receiver module is lit and the setup is finished.
METHOD2 | METHOD 3 |
|
METHOD 1 | CONNECTIONS |
| |
(supplied) |
|
TV |
|
• If Power Standby mode continues, repeat Steps 1 to 3 above.
Caution
•When the wireless receiving module setting is complete, no audio signal is output from the Rear Speaker OUT ports on the back of the main unit.
•The wireless receiving antenna is built into the wireless receiver module. Keep the unit away from water and moisture.
•For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any obstruc- tions.
•Sound will be heard from the wireless rear speakers in DVD
•In
Note
•Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to the main unit, some sound interruption may be heard due to interference.
•If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device that uses the same frequency (2.4GHz) near the system, some sound interruption may be heard due to interference.
•The transmission distance of radio wave is about 33 feet, but may vary depending on your operating environment.
If a
METHOD 1 Composite Video ....... (Good Quality)
-Connect the supplied video cable from the VIDEO OUTjack on the side panel of the system to the VIDEO IN jack on your TV.
METHOD 2 Component ....... (Better Quality)
-If your television is equipped with Component Video inputs, connect a component video cable (not supplied) from the Pr, Pb and Yjacks on the side panel of the system to the corresponding jacks on your TV.
METHOD 3 HDMI ....... (Best Quality)
- Connect the HDMI out to the HDMI input on your TV.
Note • This product operates in Interlaced scan mode (576i, 480i) for component output.
17 | 18 |