ONX254 / ONX302 / ONX304 / ONX304SQ
The diagram below shows a screw pattern for mounting your subwoofer.
M4 X 35
ILLUMINATION WIRING: Option 1
- Connect the LED + spade terminal to an accessory switched 12 volt wire. This wire should have +12V when the ignition key is “on” and 0 volts when the ignition key is “off”. You can use a toggle switch in line on this wire to manual turn the illumination off if desired and this 12V+ wire must have a 5 amp fuse in line.
Option 2
-Connect the LED + spade terminal to the Radio / CD player “remote out” wire which is also connected to the amplifier “remote” input terminal. This ire will show 12 volts when the radio is “on” and 0 volts when the radio is “off”
Connect the LED - spade terminal to chassis ground.
LED +
Speaker Wire +
1
LED
+ -
LED -
Speaker Wire -