Tripp Lite SRCABLETRAYEXP owner manual Parts List, Tools Required

1 – Introduction

SRCABLETRAY provides roof-mounted cable routing and power/data cable segregation for Tripp Lite’s SmartRack Enclosures. SRCABLETRAYEXP provides vertical expansion for SRCABLETRAY. (SRCABLETRAY also provides secure mounting points for Tripp Lite’s SRCABLELADDER accessory, sold separately. SRCABLELADDER allows cable bundles to span aisles and/or spaces between enclosures. See the SRCABLELADDER manual for more information.)

1-1 Parts List

SRCABLETRAY

A1	Trough Section (1)	A1
B1	Support Sections (2)
C1	#8-32 x 1/4 Phillips Screws (8)
D1	M6 Lock Washers (4)
E1	M6 Hex Nuts (2)

F1 24-inch Ground Cable (1)

C1 D1 E1

B1

F1

SRCABLETRAYEXP
A2 Expansion Sections (2)	A2

B2 #8-32 x 1/4 Phillips Screws (8)

B2

If anything is missing, call Tripp Lite for assistance at +1.773.869.1234. Note: SRCABLETRAY and SRCABLETRAYEXP are sold separately.

1-2 Tools Required

•Phillips Screwdriver

•13 mm Open-End Wrench or Crescent Wrench (For SRCABLETRAY installation only.)

2 – Important Safety Instructions

SAVE THESE INSTRUCTIONS

This manual contains instructions and warnings that must be followed during the installation and operation of the products described in this manual. Read all instructions and warnings thoroughly before attempting installation. Failure to comply may invalidate the warranty and cause property damage and/or personal injury.

•Install in a controlled indoor environment, away from moisture, temperature extremes, flammable liquids and gasses, conductive contaminants, dust and direct sunlight.

•Provide suitable grounding in accordance with all applicable electrical wiring regulations.

•Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the failure of the life support equipment or to significantly affect its safety or effectiveness is not recommended. Do not use this equipment in the presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide.

2