Using the TV's Controller (Panel Key)
The TV's Controller, a small joy stick like button on the rear right side of the TV, lets you control the TV without the remote control.
✎✎ The product colour and shape may vary depending on the model.
Angle adjustment wheel
Remote control sensor
When you use the Smart Touch Control, the standby LED does not work (except P button).
Camera rear
Function menu
m R P
TV Controller
✎✎ Follow these instructions facing the front of your TV.
✎✎ When selecting the function by moving the controller to the up/down/left/right directions, be sure not to press the controller. If you press it first, you cannot operate it to move the up/down/left/right directions.
✎✎ Before you use the TV camera for the first time you should check whether tape is attached at the rear of the TV camera. TV camera can be then used after adjusting the camera angle. If you do not intend to use the TV camera, move the camera lens upwards so that the lens is not revealed. In this case, Face recognition and Motion control are not available.
Power on
Adjusting the volume
Selecting a channel
Using the Function menu
Selecting the MENU (m)
Selecting the SMART HUB (™)
Selecting a Source (s)
Power off (P)
Turn the TV on by pressing the Controller when the TV is in standby mode.
Adjust the volume by moving the Controller from side to side when the power is on.
Select a channel by moving the Controller upwards and downwards when the power is on.
To view and use the Function menu, press and release the Controller when the power is on. To close the Function menu, press and release the Controller again.
With the Function menu visible, select the MENU (m) by moving the Controller to the left. The OSD (On Screen Display) Menu appears. Select an option by moving the Controller to the right. Move the Controller to the right or left, or backwards and forwards to make additional selections. To change a parameter, select the it, and then press the Controller.
With the Function menu visible, select SMART HUB (™) by moving the Controller upwards. The SMART HUB main screen appears. Select an application by moving the Controller, and then pressing the Controller.
With the Function menu visible, open the Source (s) by moving the Controller to the right. The Source screen appears. To select a Source, move the Controller back and forth. When the source you want is highlighted, press the Controller.
With the Function menu visible, select Power off (P) by moving the Controller downwards, and then press the Controller.
✎✎ To close the Menu, Smart Hub, or Source, press the Controller for more than 1 second.
English - 6