Alvin WorkMaster Jr manual ⁄8 drill bit, gently drill ¼ deep holes where, Tip

7

Insert two rear extension tubes (E) at rear of frame as shown in Figure 3. Curved black caps on tubes should be set into frame so inclines face front and back of frame. Carefully insert two front extension tubes (F) with attached brackets facing out. All four extension legs should be at their lowest position and locked with four height adjustment knobs (H). Set base aside.

Front extension tube Adjustment knob

Figure 3

Rear extension tube

Figure 4

8

Place tabletop (B) with preferred side facing down on carpeted or protected floor.
Place supplied cardboard template on board surface with edge of template at front
edge of board. Left and right edges of template should be an equal distance from
each side of the tabletop. Using a	1	⁄8" drill bit, gently drill ¼" deep holes where
marked on the template. Remove template.

TIP

Wrap masking tape ¼" from drill bit end to drill only ¼" deep to avoid drilling through

determine drilling depth. Take care to and destroying tabletop surface.

9

Carefully turn table assembly upside down and place on top of tabletop. Align holes
in front leg extension brackets (F) with holes in tabletop (see Figure 4). Fasten all
5	⁄8" screws (I) and tighten securely. Use care not to overtighten and strip.

5 ⁄8"

Screws

10	Carefully return table assembly to the upright position. Adjust
	tabletop to desired height using height adjustment knobs (H).
	You’re finished and your table is ready to use (see Figure 5).

5

WORKMASTER MODELS:

WM48-3-XB WM48-4-XB WM60-3-XB WM60-4-XB WM72-3-XB WM72-4-XB

WORKMASTER JR. MODELS:

WMJ-3-XB

WMJ-4-XB

WMJ48-3-XB

WMJ48-4-XB

WMJ-3-WBR

WMJ-4-WBR

WMJ-3-XBR

WMJ-4-XBR

©2007	ALVIN & COMPANY, INC. • P.O. Box 188, Windsor, CT 06095-0722
Phone:	860-243-8991 • Toll-Free: 800-444-2584 • Fax: 860-242-8037 • Toll-Free Fax: 800-777-2896

www.alvinco.com

LIT-A7010 5/07