Sunrise Medical 900-0880 Easytrack Bath Base KIT KIT Contents & Part Numbers Figure

A s s e m b l y o f B a t h B a s e K i t 5

EASYTRACK BATH BASE KIT

KIT CONTENTS & PART NUMBERS (FIGURE 1)

Description		Part #	Qty
1	Bath base rail	N/A	1
2	Bath post	N/A	1
3	Blue locking handle	N/A	1
4	Round blue cap	900-0720	1
5	Allen key 6mm	900-3280	1
6	Top plate	900-0400	1
7	Flat blue cap	900-1050	1
8	Blue plastic strips
	(2/post)	900-0230	2
9	Blue bath base cover	N/A	1

ASSEMBLY OF BATH BASE KIT

Tools Required:

•Step ladder

•Tape measure

•Scissors or knife

•An assistant

1.Take the bath base rail out of the box and place it on its supports or "feet".

2.Using 6mm Allen key, loosen the screws that hold the metal anchor to allow the rail to extend and retract freely to fit on your tub (Figure 2).

3.Using the same key, loosen the plas- tic post bath base so that it will slide easily (Figure 3).

4.Place the bath base rail on the edge of the tub next to the wall and extend the base so that it reaches each corner (Figure 4).

5.Slide the plastic post base so that it is approximately 16-18" from the end of the tub (Figure 5).

NOTE– Edge of the bath tub must be thoroughly cleaned and dried before placing the bath base on the tub. An Easytrack Bath Base that has been installed on an unclean or wet surface may cause injury or damage.

6.Once the bath base is in place, tight- en the metal anchor inside with the allen key. DO NOT OVER-TIGHTEN.

7.Tighten the post base in place with the Allen key. DO NOT OVER-TIGHTEN. The post base should be snug and not able to slide once tightened.

NOTE– Round foot pads under the bath base must be in contact with the tub com- pletely. The edge of the foot pad cannot be partially off the corner of the tub. See "Requirements" section.

Figure 1

Figure 2

Figure 4

Figure 3

16" – 18"

Figure 5

Bath Base Kit