Sylvania SY4100 Setting Message Rec Sel Msg 1 25 Sec, Setting Message Play Sel Msg 1 25 Sec

Setting 5

Setting 6

:The first priority dial in case of Fire. (check with the fire dept if this is acceptable)

:The first priority dial in case of Medical help. (check with the hospital if this is acceptable )

Note: The dialer will work w ith a touch tone service line only

(3)7- MSG : To set a recorded message which contains 1 segment of message for a maximum of 25 seconds. If the recorded message is less than 25 Sec, press ENTER to end the recorded message. When alarm is triggered,

it will play the recorded voice message.

Press 7 to start recording your message(it will automatically count

down from 25 Sec). Please note: The message should include pertinent information such as your name, address, and telephone number

Setting : Message Rec

Sel Msg: 1 25 Sec

When the recorded message is finished, it will automatically playback the recorded message. The LCD panel is shown below.

Setting : Message Play

Sel Msg: 1 25 Sec

(4)8 – DIAL : To set a Dial mode. (default is 2-ALL to dial all telephone numbers programmed)

Setting : Dialer Mode

1 – Single 2 – All 2

Press 1 for a single attempt dial. (the dialer will stop dialing when one of the phone numbers are answered or 3 cycle dialing attempts are complete)

Setting :	Dialer	Mode
1 – Single	2 – All	1

Press 2 for a 3 cycle attempt dial (the dialer will stop dialing when all the programmed phone numbers are answered or 3 cycle dialing attempts are complete

Note: The answered phone numbers will be excluded from the dial sequence

Setting :	Dialer	Mode
1 – Single	2 – All	2

(5)9 – CODE : To make a password change. (factory defaults, 1-Install :123456, 2- Master : 135246). If you want to change the password, key -in the 6 Digits. It will automatically show “OK”(max set 6 digits). If it is less than 6 digits, you can press ENTER after keying-in the number, and it will show ”OK”.

Setting : Change Code

1 – Install 2 – Master

9