Connecting to an External Source
GB
The auxiliary input can be used to take advantage of the sound quality of your
Examples: 
A television
A video disc player
A
To connect the external source, the source must have an audio output. In addition, you need an RCA connection cable.
1 Set the system to standby mode and disconnect it and the external source from the main.
2 Connect the audio cable to the rear of the
Connect the... | To the connector marked... |
Red jack | R (right) |
White jack | L (left) |
Connecting the Loudspeakers
The loudspeaker connector terminals are located on the rear of the system.
1 Press and hold the clamp of the speaker terminal on the rear of the unit.
2 Insert the end of the speaker cord into the terminal.
Match the polarity (colors): Red (+) to red (+) and black
Release the finger from the clamp.
Use only speakers with the same speaker impedance as indicat-
(Right Speaker) | (Left Speaker) |
3
4
5
6
For optimum sound quality, do not invert the right and left channels.
Plug the system back into the main socket and press On/Standby to switch it on.
Select the AUX source by pressing AUX.
Result: AUX is displayed.
Switch the external source on.
Adjust the volume and balance as required: | (+) | ||
Volume | Equalizer |
|
|
Example: You can watch a film and take advantage of stereo sound provided that the original sound track is in stereo (as if you were in a cinema).
SPEAKER (6Ω | ) |
R | L |
DIGITAL
OUT
(OPTICAL)
RL
AUX IN
CD Digital Out Jack
This unit can output CD digital sound signals through this jack. Use an optical cable to connect digital audio equipment. (DAT deck, MD recorder, etc.).
Remove the dust cap (1) from the CD DIGITAL OUT jack. Then, connect an optical cable plug to the CD DIGITAL OUT jack.
(1)
When the CD DIGITAL OUT jack is not being used Attach the supplied dust cap.
Directions in Installing Speaker
Installation in a place near heating apparatus, under direct lay of light or with high humidity may cause performance degradation of the speaker.
Do not install on the wall or on a high place of pole or other unstable place to prevent any safety accident caused by falling of the speaker.
Do not take the speaker apart from TV or computer monitor. The speaker near the TV or computer monitor may influence the quality of the screen display.
8