Cooking / Reheating |
| Power Levels |
The following procedure explains how to cook or reheat food.
ALWAYS check your cooking settings before leaving the oven unattended.
First, place the food in the centre of the turntable. Then, close the door
1.Press the 
button.
Result : | The 750W (maximum cooking power) | |
| indications are displayed: | |
| Select the appropriate power level by pressing | |
| the | button again until the corresponding |
wattage is displayed. Refer to the power level table.
2. Set the cooking time by Pressing the ( ) and ( 
) buttons as required.
3.Press the 
button.
Result : The oven light comes on and the turntable starts rotating.
1) Cooking starts and when it has finished the oven beeps four times.
2)The end reminder signal will beep 3 times(once every minute).
3)The current time is displayed again.
Never switch the microwave oven on when it is empty.
If you wish to heat a dish for a short period of time at maximum power(750W), simply press the +30s button once for each 30 seconds of cooking time. The oven starts immediately.
You can choose among the power levels below.
|
|
| Output |
|
| |
Power Level |
|
| EN | |||
|
|
|
|
| ||
| MWO |
| GRILL | |||
|
|
|
| |||
|
|
|
|
|
|
|
HIGH |
| 750 W |
| - |
|
|
MEDIUM HIGH | 600 W |
| - |
|
| |
MEDIUM |
| 450 W |
| - |
|
|
MEDIUM LOW | 300 W |
| - |
|
| |
DEFROST( | ) | 180 W |
| - |
|
|
LOW/KEEP WARM | 100 W |
| - |
|
| |
GRILL |
| - |
| 950 W | ||
COMBI I ( | ) | 600 W |
| 950 W | ||
COMBI II ( | ) | 450 W |
| 950 W | ||
COMBI III( | ) | 300 W |
| 950 W | ||
|
|
|
|
|
|
|
If you select higher power level, the cooking time must be decreased. If you select lower power level, the cooking time must be increased.
Stopping the Cooking
You can stop cooking at any time to check the food.
1.To stop temporarily;
Open the door.
Result : Cooking stops. To resume cooking, close the door and press 
again.
2.To stop completely; Press the 
button
Result : The cooking stops. If you wish to cancel the
cooking settings, press the Stop ( 
) button again.
You can also cancel any setting before starting by simply pressing Stop ( 
).
7