Installation OF the water dispenser line
Connect the water line to the refrigerator
-Slip the compression nut and plastic ferrule through the plastic tube.
-After inserting the sleeve, tighten the compression nut onto 1/4” compression fitting(union).
NOTE Do not overtighten the compression nut.
-Slip the compression ferrule and nut on copper (or plastic) tubing as shown.
Tighten the comperssion nut onto the compression fitting(union).
-Turn water on and check for any leakege.
Compression Nut
Ferrule
Sleeve
Compression
fitting
Ferrule
Compression Nut
NOTE Waterline must be connected to drinkable water only
(Case 2)
Check the water supply line
Connect the water pipe with coupler and tap.
-Close the main water tap.
-Connect coupler “A” to the tap.
-Every join should be protected with sealing tape.
WARRANTY INFORMATION
This water line installation is not covered by the
Follow these instructions carefully to minimise the risk of expensive water damage.
Note:
If the coupler does not fit on the current tap, go
the nearest authorised service dealer and purchase the right couplers fittings.
CAUTION
The water line must be
to the cold water pipe.
If it is connected to the hot water
pipe, it may cause the purifier to malfunction.
COUPLER “A”
TAP
Connect the water line to the refrigerator.
-Remove the compressor cover of the refrigerator.
-Connect the water line to the valve, as shown in the figure.
-When connected, check if there is any leakage. If any, repeat the connection.
-Reattach the compressor cover of the refrigerator.
WATER LINE
CONNECTION NUT
COMPRESSOR COVER OF REFRIGERATOR
34