480 |
|
480C |
|
Paper shredder |
4. Supplies | 7. Operation |
–Bags for cut material
(Packed in dispenser carton, 50 or 100 bags to a roll depending on size. Contact Fellowes or your local Fellowes dealer for the stock number of the bag that fits your machine.)
–Cutting block oil for
5. Installation
–Refer to separate
–Operate this product only from the type of power source indicated on the marking label
–Install the paper shredder so that the plug is easily accessible
–Shredder must be operated only in upright position
–Set up paper shredder so that the ventilation slots are unobstructed. To ensure sufficient ventilation of the shredder a minimum distance of 4" (10 cm) to the wall or to the furniture must be maintained.
6. Caution
Never insert hand, fingers or any foreign objects into the feed opening.
Serious injury may result.
Keep all loose articles of clothing, ties, jewelery, long hair or other loose objects away from feed opening.
Injury may result.
Always turn off and unplug the machine before moving, servicing, cleaning or any other conduct other than normal operation.
Serious injury may result.
Before start-up
–Undo the wing screws securing the unit during transportation
Read operating instructions before putting shredder into operation
Insert plug in power outlet
Install waste bag for shredded material
–Open front door and completely remove bag frame from cabinet
–Fold new bag around frame. Allow bag to overhang frame by approximately 7" (20 cm).
–Slide frame with bag back into cabinet
–Close cabinet door.
Switching equipment ON
1 – Press rocker switch to pos. 1
• Switch locks in "on" position
•Equipment is ready for operation (stand by)
• Green LED lights
–Feed paper
•The shredding process is started by
•When the shredding is complete, the cutting system automatically stops after approx. 3 sec.
Switching equipment OFF
– Press rocker switch to pos. 2
2 • Switch resets to center position and the machine is turned off.
Feeding continuous forms
–Pass the leading edge of the form under the paper guide roller (1) and into the paper feed opening (2).
2 | 1 |
6 | Edition 01/03 |