troubleshooting
PROBLEM | SOLUTION | |
|
| |
Motor downs and does | • Check cable, plug and socket. | |
not start. | • Leave to cool. | |
|
| |
Suction force is gradually | • Check for blockage and remove. | |
decreasing. | ||
| ||
Cord does not rewind | • Pull the cord out 2~3m and push down the cord rewind button. | |
fully. | ||
| ||
Vacuum cleaner downs, | • Check hose and replace if required. | |
does not pick up dirt | ||
| ||
Water leakage from the | • Check rubber packing inserted tightly at the upper part. | |
dust bin. | • Check rubber packing to the lever at the bottom of the dust | |
| bin. | |
|
| |
Excessive water drops | • Some droplets on the inside body are to be expected. | |
from the inside of the | ||
Please dry the aqua cyclone fully. | ||
body. | ||
| ||
Dirty water comes out | • Check the filter is located properly. | |
of the top of the main | • If the amount of water becomes excessive, check if water | |
body | inside dust bin is over the max line and make the water level is | |
| under the max line. | |
|
| |
Water comes out from | • Check the water level of the aqua cyclone. | |
the back cover. | • Please operate the vacuum cleaner without the aqua cyclone | |
| until water does not come out from the back cover. | |
|
| |
Low or decreasing | • Please check filters. If required clean it as illustrated in the | |
suction. | instruction. If filters are out of conditions, change them to new | |
| one. | |
|
| |
Body overheating | • Please check filters. If required clean it as illustrated in the | |
| instruction. | |
|
| |
Static electricity | • Please decrease power suction. | |
discharge | ||
| ||
Unpleasant smell during | • Please note that there may be a slight smell during vacuuming | |
vacuuming | when the cleaner is new | |
|
|
14_ troubleshooting