Installation Instructions | Model: FTR Series |
collapsed anchors (20). Tighten until secure (See Figure 4).
(20) |
|
(4 places) | (30) |
| (4 places) |
(10) | Anchor |
Screw | |
| (4 places) |
Figure 4: Installation to Drywall
INSTALL DISPLAY TO MOUNT
NOTE: Proper interface must be attached to display. See instructions that come with interface assembly.
1.Open latching flag by rotating flag clockwise on plate (10) (See Figure 5).
Latching |
Flag |
(10) |
Figure 5: Open Latching Flag
2.Lift and maneuver display such that all buttons fit into button openings on plate (10). Lower display firmly into place. Ensure each button has fully seated in its button opening (See Figure 6).
NOTE: Mounting buttons are shown in the 100mm x 100mm pattern. Plate (10) will also accommodate a 75mm x 75mm pattern.
Button location for 100mm x 100mm pattern (4 places)
Button location for 75mm x 75mm pattern (4 places)
NOTE: Display not shown for clarity.
Figure 6: Install Display to Plate
3.Close latching flag by rotating flag counterclockwise on plate (10) (See Figure 7).
NOTE: An optional padlock may be used to secure latching flag.
Latching
Flag
(10)
NOTE: Display not shown for clarity.
Figure 7: Close Latching Flag
4. Connect cables to display as required.
REMOVE DISPLAY FROM MOUNT
1.Disconnect all cables from display.
2.Open latching flag by rotating flag clockwise on plate (10) (See Figure 5).
3.Lift and maneuver display mounting buttons out of button openings.
5