Desa AT Series owner manual Unpacking, Product Identification

Page 3

SAFETY INFORMATION PRODUCT IDENTIFICATION UNPACKING

3

SAFETY INFORMATION

Continued

Do not use heater in living or sleeping quarters.

Keep appliance area clear and free from combustible materi- als, gasoline, paint thinner, and other flammable vapors and liquids. Dust is combustible. Do not use heater in areas with high dust content.

This heater is equipped with a thermostat. Heater may start at anytime.

Check heater for damage before each use. Do not use a dam- aged heater.

Use only propane/LP gas set up for vapor withdrawal.

Keep propane tank(s) below 100° F.

Do not use heater in a basement or below ground level. Pro- pane/LP gas is heavier than air. If a leak occurs, propane/LP gas will sink to the lowest possible level.

Use only the hose and factory regulator provided with the heater.

Check hose before each use of heater. If highly worn or cut, replace with hose specified by manufacturer before using heater.

Do not alter heater. Keep heater in its original state.

Do not use heater if altered.

Keep heater at least six feet from propane/LP tank(s). Do not point heater at propane/LP tank(s) within 20 feet.

Minimum heater clearances from combustibles: Outlet: 8 Ft. Sides: 2 Ft. Top: 6 Ft. Rear: 2 Ft.

Locate heater on stable and level surface if heater is hot or running.

Keep children and animals away from heater.

Turn off propane/LP supply and unplug heater when not in use.

Never block air inlet (rear) or air outlet (front) of heater.

Never move, handle, or service a hot, operating, or plugged-in heater.

Never attach duct work to front or rear of heater.

Use only original replacement parts. This heater must use de- sign-specific parts. Do not substitute or use generic parts. Im- proper replacement parts could cause serious or fatal injuries.

Do not adjust regulator below 7 psig or above 20 psig.

UNPACKING

1.Remove all packing items applied to heater for shipment. Keep plastic cover caps (attached to inlet connector and hose/regu- lator assembly) for storage.

2.Remove all items from carton.

3.Check all items for shipping damage. If heater is damaged, promptly inform dealer where you bought heater.

PRODUCT IDENTIFICATION

Hot Air Outlet (Front)

Handle

Fan

Guard

Outer Shell

On/Off Switch

Inlet Connector

Power

Cord

Hose/Regulator

Assembly

REAR VIEW

Thermostat Knob

Figure 1 - 375,000 Btu/Hr Models

For more information, visit www.desatech.com

103018

Image 3
Contents PROPANE/LP Construction Heater Safety Information Table of ContentsProduct Identification UnpackingPROPANE/LP Supply InstallationTheory of Operation VentilationOperation To Start HeaterTo Stop Heater To Restart Heater Storage Service ProcedureMaintenance Cleaning FANService Procedure Specifications Wiring DiagramsParts not Under Warranty Accessories Replacement PartsTechnical Service Service Publications Parts Under WarrantyBLP375AT SBLP375AT Illustrated Parts BreakdownParts List Warranty and Repair Service