Meeting Installation Requirements

setting up your washing machine

Electrical supply and grounding

To prevent unnecessary risk of ﬁre, electrical shock, or personal injury, all wiring and grounding must be done in accordance with the National Electrical Code ANSI/FNPA, No. 70 Latest Revision and local codes and ordinances. It is the personal responsibility of the appliance owner to provide adequate electrical service for this appliance.

Never use an extension cord.

WARNING Use only the power cord that comes with your washing machine. When preparing for installation, ensure that your power supply offers:

•220V~240V 50Hz 15 AMP fuse or circuit breaker

•Individual branch circuit serving only your washing machine

Your washing machine must be grounded. If your washing machine malfunctions or breaks down, grounding will reduce the risk of electric shock by providing a path of least resistance for the electric current.

Your washing machine comes with a power cord having a three-prong grounding plug for use in a properly installed and grounded outlet.

Never connect the ground wire to plastic plumbing lines, gas lines, or hot water pipes.

Improperly connecting the equipment-grounding conductor can result electrical shock. Check with a qualiﬁed electrician or serviceman if you are unsure if the washing machine is properly grounded. Do not modify the plug provided with the washing machine. If it does not ﬁt the outlet, have a proper outlet installed by a qualiﬁed electrician.

Water Supply

Your washing machine will ﬁll properly when your water pressure is 50 kPa ~ 800 kPa. Water pressure less than 50 kPa may cause water valve failure, not allowing the water valve to shut off completely. Or, it may take the washing machine longer to ﬁll than what the controls allow, resulting in your washing machine turning off. (A ﬁll-time limit, designed to prevent overﬂows/ ﬂooding if an internal hose becomes loose, is built into the controls.)

The water taps must be within 4 feet (122cm) of the back of your washing machine for the provided inlet hoses provided to reach your washing machine.

Most plumbing supply stores sell inlet hoses of various lengths up to 10 feet (305cm) long. You can reduce the risk of leaks and water damage by:

•Making water taps easily accessible.

•Turning off taps when the washing machine is not in use.

•Periodically checking for leaks at water inlet hose ﬁttings.

Before using your washing machine for the ﬁrst time, check all connections at the water WARNING valve and taps for leaks.

14_ setting up your new washing machine

WF0350N1-02896D_EN.indd 14

2011-2-26 14:09:26