Chief Manufacturing LCD2TS installation instructions Assembly And Installation

Installation Instructions				LCD2TS
Assembly And Installation
For RPA Models Only		6	(F)
	WARNING: Failure to provide adequate structural strength
	for this component can result in serious personal injury or
	damage to equipment. It is the installer’s responsibility to
	make sure the structure to which this component is attached
	can support five times the combined weight of all equipment.		(C)
	Reinforce the structure as required before installing the
	component.
1. Set the base plate (B) on a flat stable work surface and
	adjust the feet as necessary.		5	(I)x2
2. Thread the 1-1/2" pipe section (C) into the base plate and
	tighten.
3.	Secure NPT pipe to base plate using one 5/16-18 x 3/8" set
	screw (I).
4. Attach RPA to projector arm (A) using four 1/4-20 X 1-1/2"
	carriage bolts (H), four 1/4-20 acorn nuts (G) and 1/4" flat		Figure 2
	washers (L). (See Figure 1)
		10. Adjust projector for correct registration.

4	(G)x4	(C)
(L)x4
		(A)
RPA
		Adjustable
		Feet
(H)x4

Figure 1

5.Slide both projector arms (A) onto the 1-1/2" vertical pipe section (C) and secure using two 5/16-18 x 3/8" set screws

(I) on each arm. (See Figure 2)

6.Thread 1-1/2" safety nut (F) onto threaded end of the 1-1/2" pipe section. (See Figure 2)

For RPM Models Only

1.Proceed with Steps 1-3 under For RPA Models Only.

2.Place RPM on its top so that four screw holes are visible through the square in the RPM base. (See Figure 3)

3.Insert four 1/4"-20x1-1/2" (K) button head cap screws into the bottom of the RPM. (See Figure 3)

NOTE: The RPM base is not shown in Figure 3 for clarity only. It should NOT be removed for this installation process.

	(D)
2	4 screw
	holes
	RPM
	(M)x4
	RPM base not
	shown for
	clarity only.
	(K)x4

7.Mount projector hanging bracket to your projector (see RPA instructions).

8.Partially thread 10-24 thumbscrews onto 10-24 studs at top of hanger bracket plate. The quantity of thumbscrews may vary from three to six.

9.Align studs with key slots of RPA, slide RPA into place, and secure RPA by tightening thumbscrews.

Figure 3

4.Place four nylon spacers (M) onto the screws as shown in Figure 3.

5.Tighten the screws through the nylon spacers and into the two interface brackets (D). (See Figure 3)

5