Samsung DV70H4400CW/EE manual Installation Stacking, Repeat the above step with the right side

INSTALLATION STACKING

In case of purchasing the additional stacking kit, contact our Samsung service center or local distributers. [Part no. SK-DH / SK-DA / SKK-DF]

The stacking kit differs depending on the model.

1. Carefully lay the dryer on its side. Use the packing material so you don’t scratch the finish on the dryer.

2. Install rubber pads to dryer base.

• Locate the 4 rubber pads in the parts package. Insert the rubber pads into the holes at the bottom of the levelling legs.

• Purchase the stacking-kit package additionally.

INSTALLING YOUR DRYER

3.Set the dryer upright.

The stacking kit can only be installed for Samsung family CAUTION products.

Bracket-Stacking

4.Install bracket to dryer.

•Remove washer top cap screw from the rear left. Align left bracket holes with top cap screw hole on rear left of the unit and replace screw.

Leave screw loose so dryer hole alignment will be easier.

• Repeat the above step with the right side.

Screw

5. Install dryer and bracket on washer.

• Lift the dryer on top of the washer. Protect the washer	Dryer
WARNING control panel with cardboard or other protection. Be
sure to lift the dryer high enough to clear the washer
control panel.
• More than two people are recommended to lift the	Washer
dryer into position because of its weight and size.
Failure to do so could result in injury.

•Align the holes in the bracket with the holes in the

back of the dryer.Using a screwdriver, attach the M4x12 tapping screws.

•Tighten the washer bracket screws ; then tighten all stacking kit screws.

English - 17

DV80H4000CX-03408D-07_EN.indd Sec3:17 2016-01-19 ￿￿ 3:03:39