10 Specifications
10.3 Standard Signal Mode Table
This product can be set to only one resolution for each screen size to obtain the optimum picture quality due to the nature of the panel. Therefore, a resolution other than the specified resolution may degrade the picture quality. To avoid this, it is recommended that you select the optimum resolution specified for the screen size of your product.
Check the frequency when you exchange a CDT monitor (connected to a PC) for an LCD monitor. If the LCD monitor does not support 85Hz, change the vertical frequency to 60Hz using the CDT monitor before you exchange it with the LCD monitor.
| Model Name |
| U28E590D / U24E590D | |||
|
|
|
| |||
Synchronization |
| Horizontal Frequency | 30 – 135 kHz (DisplayPort) | |||
|
|
| 30 | – 90 kHz (HDMI1) | ||
|
|
| 30 | – 135 kHz (HDMI2) | ||
|
|
|
| |||
|
| Vertical Frequency | 56 – 75 Hz (DisplayPort) | |||
|
|
| 24 | – 75 Hz (HDMI1/HDMI2) | ||
|
|
|
| |||
Resolution |
| Optimum Resolution | 3840 x 2160 @ 60 Hz (DisplayPort) | |||
|
|
| 3840 x 2160 @ 30 | Hz (HDMI1) | ||
|
|
| 3840 x 2160 | @ 60 | Hz (HDMI2) | |
|
|
|
|
|
| |
|
| Maximum Resolution | 3840 x 2160 | @ 60 | Hz (DisplayPort) | |
|
|
| 3840 x 2160 | @ 30 | Hz (HDMI1) | |
|
|
| 3840 x 2160 | @ 60 | Hz (HDMI2) | |
|
|
|
|
|
|
|
If a signal that belongs to the following standard signal modes is transmitted from your PC, the screen will automatically be adjusted. If the signal transmitted from the PC does not belong to the standard signal modes, the screen may be blank even though the power LED turns on. In such a case, change the settings according to the following table by referring to the graphics card user manual.
10 Specifications 92