Oreck 2635RH warranty Bulb Replacement, Ring

Page 7

Stuffing or Blockage

Under certain conditions it is possible to stuff or block the intake tube and the lower tube assembly. If your vacuum cleaner does not pick up properly, or makes unusual noise and the outer bag does not fluff up or balloon open, follow the following steps:

WARNING: Unplug cord from electrical outlet before servicing.

5.Many times blockage occurs due to a full dust bag causing dirt to back down the air flow system. When that happens, the blockage will be at the top of the system, starting in the area where the dust bag connects to the connector assembly. See illustration F.

F

Connector

Deflector

Opening

A

Intake Opening

B

Intake Opening

Retainer

Spring

C

Fan

Housing

O-ring

D

E

1.Check for blockage at the mouth of the intake opening. See illustration A. If there is blockage, remove it with long-nose pliers, a screwdriver or coat hanger. If you can not reach the blockage, remove baseplate. See illustration B.

2.If the blockage is not at the base, remove lower tube. See illustration C. Unhook retainer spring, releasing bottom of bag. Twist lower collar counterclockwise to slide up. Pull tube out of base. Check for blockage. If blockage is in the tube, remove with a coat hanger.

3.If tube is not blocked, look into fan housing. See illus- tration D. Remove debris with long-nose pliers, a screwdriver or coat hanger.

4.To reassemble, check O-ring on tube, and replace if damaged. Vacuum will not operate properly without the tube O-ring. Slide O-ring to approximately 2" from base of tube. Replace tube by first lining up slot at base of tube with inner tab inside fan housing. Then reinsert tube and push down until the tube is seated. Make sure O-ring is in place against fan housing opening. Replace and tighten collar until collar locking tabs are locked in place. See illustration E. Make sure collar is not cross threaded on housing.

NOTE: If the “Stuffing or Blockage” actions do not correct the problem, contact an ORECK authorized service center or call the customer service center at: 0845 603 0153.

IMPORTANT: On plush and new carpets, stuffing may occur due to excessive fuzz and loose cuttings in the carpet. Stuffing could occur for the first few cleanings until all the loose material is removed. Due to the high efficiency of the cleaner, many older carpets will cause stuffing when the cleaner is first used on them.

Bulb Replacement

Remove lamp housing by removing two (2) screws in the the top of the lamp housing. Pull burned out bulb from holder and replace with new bulb. Use only Oreck replacement parts. Reassemble lamp housing by replacing two screws in the top of the lamp housing. WARNING: Unplug cord from electrical outlet before servicing.

Using An Oreck Fresh Air® Tab

Your ORECK XL vacuum cleaner has a special Oreck Fresh Air® tab pocket. This pocket is located inside the outer bag in the area where the disposable paper bag attaches to the intake tube. Insert tablet in pocket.

7

Image 7
Contents 2635RH Table of Contents Devon EX1 1XB Maintenance Customer ServiceWarranty 0845 603BAG Removal Assembly To Replace Filter Dust BagOperating Instructions How to Replace a Worn Belt To Adjust or Replace Brush Ring Bulb ReplacementSave Service CALLS...CHECK These First Troubleshooting Guide

2635RH specifications

The Oreck 2635RH is a versatile and powerful upright vacuum cleaner designed to provide exceptional cleaning performance for both carpets and hard floors. This model is part of Oreck's renowned line of vacuum cleaners, known for their lightweight design and efficiency.

One of the standout features of the Oreck 2635RH is its ultra-lightweight construction, weighing in at just 8 pounds. This makes it easy to maneuver around the home, allowing users to carry it up and down stairs or move it from room to room without feeling fatigued. The ergonomic handle adds to the convenience, providing a comfortable grip that enhances user experience during extended cleaning sessions.

The Oreck 2635RH is equipped with a powerful motor that delivers impressive suction power, ensuring deep cleaning in various types of flooring. It utilizes a unique roller brush system that effectively lifts dirt, debris, and pet hair from carpets and rugs, while also being safe for hard floors. This dual functionality allows users to transition seamlessly between different surfaces without the need for separate cleaning tools.

Another notable technology in the Oreck 2635RH is the filtration system, which features a top-fill design that helps to maximize dirt capacity while minimizing clogging. The vacuum uses a 10-inch cleaning path, enabling it to cover more area with each pass, which is especially beneficial for larger spaces. Additionally, it comes with a hypoallergenic bag that captures 99% of dust and allergens, making it a great choice for households with allergy sufferers.

The Oreck 2635RH also includes a set of convenient attachments, such as a dusting brush and a upholstery tool, which enhance its versatility. These accessories allow users to clean various surfaces, including upholstery and curtains, ensuring a comprehensive cleaning experience.

In summary, the Oreck 2635RH is an exceptional vacuum cleaner that combines lightweight design with powerful suction performance. Its intelligent technologies, such as the efficient roller brush system and advanced filtration, contribute to its ability to tackle dirt and allergens effectively. Ideal for both carpets and hard floors, the Oreck 2635RH is a reliable choice for anyone seeking a high-quality cleaning solution for their home.