Parts List, Assembly, Operating Instructions

Parts List

To assist you in identifying components of your vacuum, the parts have been numbered as follows:

1	Handle tube, upper
2	Tube, lower			10		11
3	Power head			9		11
4	Outer bag			9		1
4	Outer bag				12	1
5	Paper filter dust bag				12
5	Paper filter dust bag
6	Power cord
7	Retaining spring	5			13	16
8	Bag clip	5
			4
			4
9	Zip fastener
10	ON/OFF switch				2	6
11	Cord hook				2


12	Plastic loop/cable clamp
13	Connector assembly		8	7	14	15
14	Fan housing			7	14


15	Cord assembly
16	Cord strain relief assembly			3

Assembly

fig. 1 Before assembling appliance, remove two screws from connector assembly. Remove cardboard insert by pulling upward.

fig. 2 With ON/OFF switch facing the front of the unit, slide upper handle section over matching section of the connector assembly. Hold tab of cord strain relief flush with TOP hole in connector assembly. Insert screw through hole in tab of cord strain relief and firmly tighten to connector assembly. Insert remaining screw in botom hole of connector assembly and tighten firmly.

NOTE: The power cord comes installed in the cord strain relief. Should the power cord come loose, simply pinch the power cord together and slide approximately 1 - 2 inches through hole in cord strain relief. Carefully slide power cord over clamp on the the cord strain relief and pull excess until the power cord is tightly rested under clamp.

fig. 3 Attach cord to cord clip by pressing cord above and below clip ensuring the cord is fully rested in clip.

Operating Instructions

Make sure disposable paper filter dust bag is in place. DO NOT operate the cleaner without a paper filter dust bag. Plug the power cord into an electrical outlet and press the ON(l) - OFF(O) switch on handle assembly when ready to operate.

Up-Position Lock

fig. 4 Place foot on power head and lean handle back gently to release lock for vacuum use. Return handle to the full upright position to engage lock.

NOTE: Do not operate the unit while in the upright and locked position. Do not let the unit run while in any one stationary position for any period of time. Keep the unit moving while in operation.

For Easy Power Cord Storage

fig. 5 Wrap power cord around cord hook on handle and cord hook on connector.

Operating Recommendations

This new ORECK XL High-Speed Upright is one of the finest, fastest, and strongest units in its class. You’ll love the way it cleans, gets under things, and it’s SO lightweight and easy to use.

The following are a few simple suggestions regarding its operation:

1.When inserting a new disposable paper filter dust bag—FIRST PUFF OUT and OPEN THE BAG.

2.When the disposable filter dust bag is full, REPLACE IT.

3.If at any time the machine does not pick up properly or makes an unusual noise, STOP OPERATION and service.

4.Although your upright will pick up pins, paper clips, and other small objects, it is recommended that these be removed from the floor before you vacuum. Failure to do so may result in permanent damage to the motor suction fan and its housing.

5.WARNING: Do not use your vacuum cleaner on damp or wet surfaces. This will cause damage to the vacuum cleaner and is dangerous to the user. Damage caused by use on wet or damp surfaces is not covered under warranty.

6.REPLACE THE BELT EVERY 6 MONTHS.

7.Change the disposable filter dust bag at least once a month— even if it is not full! The collected dust in the dust bag can cause odor, attract moisture, and can affect the efficiency of the cleaner.

8.DO NOT run the vacuum cleaner over the cord. The revolving brush could damage the cord.

9.Use caution when vacuuming over area rug edges and fringe.

General Information

The performance of your new cleaner greatly depends upon care and maintenance. The instructions in this manual will guide you in performing basic care and maintenance. To obtain the most satisfying years of service read the instructions and keep them handy for future reference.

Disposable Paper Filter Dust Bags

Disposable paper filter dust bags play a very important role in the efficiency of your ORECK vacuum cleaner. The purpose of the paper bag is to trap dirt, but at the same time it must be porous enough to allow air to pass through. If the paper bag becomes clogged, no air can pass through the cleaner and cleaning cannot take place, regardless of the cleaner’s power.

To keep your cleaner operating at maximum efficiency, change the dust bag frequently. DO NOT FILL ABOVE THE LINE INDICATED ON THE

DUST BAG.

Be sure the disposable paper filter dust bag is installed properly.

All paper dust bags are not the same. Your ORECK disposable dust bags have been designed to be used with the ORECK cleaner. Using bags other than genuine ORECK TYPE CC disposable bags will affect the cleaning ability of your cleaner and could cause damage to it.

The Belt

The belt on your vacuum cleaner controls the speed of the revolving brush and is very important for the effective operation of the cleaner. If the belt becomes stretched or cut, it will cause the revolving brush to stop completely or slow down. See instructions in the manual for replacing belt.

An extra belt is stored in the baseplate of your cleaner. When buying replacement belts, use ONLY ORECK genuine belts. Belts other than ORECK belts will not operate the revolving brush correctly and may create undue stress which will cause damage to the motor and brush bearings. Using belts other than ORECK belts will void the warranty.

Lubrication

The vacuum cleaner motor bearings are factory lubricated and sealed. Further lubrication is not required.

U2555RH, U2565RH specifications

The Oreck U2555RH and U2565RH vacuum cleaners represent a blend of innovation and traditional cleaning prowess, designed to meet the needs of both residential and commercial users. Known for their lightweight design and powerful suction capabilities, these models are perfect for anyone looking to maintain a clean and healthy living or working environment.

One of the standout features of the Oreck U2555RH and U2565RH is their weight. Weighing just 8 pounds, these vacuums are incredibly easy to maneuver, allowing users to clean large areas without the fatigue often associated with heavier models. The ergonomic design includes a comfortable handle, reducing strain on the wrist and making them suitable for prolonged use.

Both models are equipped with Oreck's renowned direct suction technology, which ensures that dust and debris are efficiently lifted from carpets and hard floors alike. This technology minimizes the loss of suction, a common issue in many vacuum cleaners, ensuring consistent performance throughout the cleaning process. The dual-speed power switch allows users to adapt the suction for various surfaces, providing optimal cleaning whether on low-pile carpet or hard floors.

Another key feature of the Oreck U2555RH and U2565RH is their hypoallergenic filtration system. These vacuums utilize a top filtration bag that captures 99% of dust, allergens, and particulate matter as small as 0.3 microns. This is particularly beneficial for allergy sufferers, as it helps maintain better air quality in the home or workplace.

The U2565RH model distinguishes itself with additional features such as a handy on-board tool kit that includes a dusting brush, upholstery tool, and crevice tool, perfect for tackling various cleaning scenarios. The vacuum's low-profile design allows it to easily clean under furniture, reaching those often neglected areas.

Both models also emphasize durability and reliability. Made with high-quality materials, they are built to withstand the rigors of daily cleaning tasks. The Oreck U2555RH and U2565RH also feature a long power cord that extends reach without the need for constant outlet changes, further enhancing user convenience.

In conclusion, the Oreck U2555RH and U2565RH vacuum cleaners combine lightweight design, powerful suction, and effective filtration technologies, making them an excellent choice for anyone seeking efficient and reliable cleaning solutions. Whether for home use or in a professional setting, these vacuums are equipped to deliver outstanding results.